That test cinches it...
John in NM
Even a very small motor should pass that test 
I was a bit skeptical of the bearings, because every time I've had bad bearings I knew it, owing to the truly horrible noises they make 
Glad you got it sorted out.
Knowledge You Can Build On — Est. 1998
That test cinches it...
John in NM
Even a very small motor should pass that test 
I was a bit skeptical of the bearings, because every time I've had bad bearings I knew it, owing to the truly horrible noises they make 
Glad you got it sorted out.
Re: A question about my table saw
Keith Newton
Before you give up on that motor, you ought to take off the end, and just see if anything obvious looks wrong, like really pitted points. You may be able to just file them, or drag a folded piece of sandpaper between them, to get better contact. There is a chance that something like that just won't let enough amps through to run at full power. It is easy enough to do, and cheaper than a re-build.
Just make sure it isn't still plugged in.