Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

conduit wire pulling trick

Posts

conduit wire pulling trick

#1

conduit wire pulling trick

Jerry Gibbs

Just used a trick shown me by an electrician. Firmly tie mason line or similiar to a wad of soft cloth that snugly fits inside the conduit. Use a vacuum to pull the wad and string through and go from there. Works slick. Jerry

Re: conduit wire pulling trick

#2

Re: conduit wire pulling trick

Bill Houghton, Sebastopol, CA

Yep. Known by some folks as a "mouse," for obvious reasons.

The "trick" that took me way too long to learn is the use of pulling lubricant. It's messy, but it makes pulling so much easier.

Re: conduit wire pulling trick

#3

please explain pulling lubricant


Re: conduit wire pulling trick

#5

Re: conduit wire pulling trick

Paul Cates - Henderson, KY

That trick saved me after I laid 150' of 1" conduit down a hill behind my house. I thought I could just shove some stiff wire through, but uh uh. I asked my uncle what to do and he told me about the vacuum method. I said no way but he was right! I used a round foam plug with hooks on each end from the electrical supply store, but I'll try your homemade version next time. I was surprised at how much force it took to pull the plug against the vacuum.

Re: conduit wire pulling trick

#6

That's a LONG run

Bill Houghton, Sebastopol, CA

I can't recall what the code run is before you come back to the surface to install a pulling box. I think it may be less than that. But it sounds like you got the job done.

Re: conduit wire pulling trick

#7

Re: That's a LONG run

Paul Cates - Henderson, KY

I agree that's a long run for 12/2 or similar, but I used the conduit to run Cat6 to an antenna for my fixed point wireless internet. Pretty easy to pull that with no wire lube.

Re: conduit wire pulling trick

#8

This also works ...

Mike Farinella

Take a fender washer, tie a string to it (mason's line), and blow it through the tubing with an air compressor. It worked great on my new shop/garage (~85 ft).

Re: conduit wire pulling trick

#9

Re: This also works ...

Larry in nw ohio

When I was working on maintanance and I always had to do things differently and ran wire by myself at times, especially in ceiling runs, I would push thru 10 to 20 feet at a time. Then close that end and go another 10 or so feet and push that thru the conduit. I would do that till the end. It would save me running the whole end with fishtape. Also at that time we had to put a pull box every 150 feet. Larry