Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Scew I got from Lake Erie Toolworks

Posts

Scew I got from Lake Erie Toolworks

#1

Bob

Scew I got from Lake Erie Toolworks 

Bob

I ordered the 24” X 2.5” Wood screw and nut with the brass garter and handle. I have the legs milled and cut to length but it just dawned on me I don’t know how far down to set the screw and drill the hole. Is there a guide line to go by for how far down to go? I would think its at a level that would be easy to reach and turn without bending but I am not sure. I am only going to instal a leg vice for now. The bench will be 7’ long and 34.5” high with mortise & tenon for the top to sit on/in and will not be fastened to the bench for now, the top is 3.5” thick and I may have a center board that can be turned around for a planing stop.

Re: Scew I got from Lake Erie Toolworks

#2

craigd

Re: Scew I got from Lake Erie Toolworks

craigd

I put my leg vise screw 9" below the top of the bench (33.5"). Works fine. If it was up an inch or two, it would still work for the things I do. For my work, the limiter is jointing wide boards and how high I want them above the bench top. There is a reach but it doesn't bother me (neither does the pin) but I'm only 5'6".

Re: Scew I got from Lake Erie Toolworks

#3

Bob

Re: Scew I got from Lake Erie Toolworks

Bob

I was looking at an old issue of Pop WW (Aug 2010) that had an article by Christopher Schwarz and the one in that article showed 10" I thought "That sound about right" I was wondering if anyone had any suggestions or found a better way. BYW I am not a carver but I was thinking it would be kind of cool to carve a pair of crossed legs top to bottom, I may give it a try.

Re: Scew I got from Lake Erie Toolworks

#4

Re: Scew I got from Lake Erie Toolworks

roger lance

Bob....I can not help you out on your question....but I must say that is one very nice looking product you got from those folks.

Re: Scew I got from Lake Erie Toolworks

#5

Bob

Re: Scew I got from Lake Erie Toolworks

Bob

I think I settled on 10" and a carving on the leg vice of a pair of crossed legs from the skirt down I thought it may make my bench sexy.