Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

OT-Welding Question

Posts

OT-Welding Question

#1

OT-Welding Question

tom

I want to make a bike repair stand and I most everthing figured out I have a question.

I want to use a black pipe union to make an adjustment feature. What I wouls like to do is weld a rod to serve as a handle to losen and thighten the union.

Can I weld a piece od steel to the flat of a uniuon? Will a mig welder work?

Thanks

Re: OT-Welding Question

#2

Maybe

Dick Coers

But depends on what the union is made of. I think on the majority of them, the nut appears to be some grade of cast iron. In that case, I've not seen a wire that can be used in a mig. But I'm more of a farmer type welder than a seriously trained guy so there may be a wire that will work that I have not seen. Brazing will definitely work with good joint prep.

Re: OT-Welding Question

#3

Re: OT-Welding Question

Robin Corell in Atascadero CA

the fittings are cast but they are ductile and therfore weldable. A greater concern is that many are galvanized and when you weld them the zinc flashes off. Weld in a well ventilated area and try not to breathe the fumes and you will likely be fine.

Robin

Re: OT-Welding Question

#4

Re: OT-Welding Question

John in NM

If you can bend a rod or strap across the union nut and then weld it to the nut it will probably work. The few times I've welded to ductile iron parts the weld was weak but it would hold well enough for what you describe. If you just want a rod sticking out one face of the nut, welding probably won't be strong enough, you need quite a bit of weld area to keep it from breaking.

A mig will work fine, I'd do it in a series of short welds so as not to warp the nut. No idea if it would warp, but given that its a fitted part I tend to be more careful.

Re: OT-Welding Question

#5

craigd

Re: OT-Welding Question

craigd

I've tried to arc weld cast iron a couple of times with miserable results (spider cracks or the puddle shrinks and pulls away from the cast iron, I was using a nickel rod). I would try brass brazing.

You can also buy repair stand heads and make a stand. I bolted a chunk of wood to mine and just stick it in the vise when I work on a bike (which is often).

Re: OT-Welding Question

#6

Re: OT-Welding Question

Kurt

If it's galvanized, you could grind the galvanized coating off the surfaces you're going to weld. You still need to be aware of toxic fumes though. Form a J shaped piece of flat stock so you could weld two opposite flats? or maybe JB weld? I've never used the stuff but some swear by it.

Re: OT-Welding Question

#7

Re: OT-Welding Question

tom

Thnaks all. What I am ending up doing is using a hose clampmand slotting a piece of angle iron and clamping it. Saves me a trip ,for now, to my brother-in-law's.

Re: OT-Welding Question

#8

Re: OT-Welding Question

Jason Waters

Tom,

I would buy a repair stand head at least. I've done the homebrew on these and it's just not the same. Stands aren't as expensive as they once were. That's my take on this item.

I've welded fittings with a MIG, and if zinc, I usually grind off the zinc prior to welding.

Jason