Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

OT Mansfield toilet hard to flush question

Posts

OT Mansfield toilet hard to flush question

#1

OT Mansfield toilet hard to flush question

Barry Irby

My son is renting a place that has a Mansfield toilet that is very difficult to flush. (I know "difficult" when I see it, been doing home inspections a long time.) This one has a plastic lever arm and does not have a flapper, but a cylinder that is fat at the bottom with some sort of rubber gasket. Any suggestions on what might be the problem and how to fix it?

Re: OT Mansfield toilet hard to flush question

#2

Re: OT Mansfield toilet hard to flush question

Larry in nw ohio

Barry I think the first thing I would do is disconnect the chain that hooks from the arm and the center "flapper thingy" and see how hard the arm works and work with the center and see how hard that is to pull up by hand. And kind of work from there and look and see anything. Good Luck. Larry

Re: OT Mansfield toilet hard to flush question

#3

Re: OT Mansfield toilet hard to flush question

waroland

I found this on the internet:

Subject: Mansfield Toilet Flushes Hard

Question

We have 3 Mansfield toilets in our home, built in 2006. 2 on the second floor and 1 on the main floor. The 1 on the main floor is getting increasingly difficult to flush. I have called the plumbing company who installed it and they suggested replacing the handle, which has done nothing to help. I checked the other 2 toilets in the house and it seems that the plunger type thingy that lifts up to empty the tank is suctioned much more in the toilet on the main floor. I don't want to spend $50 for a service call. Any suggestions? Thanks.

Answer

Hi Linda,

Mansfield toilets are usally good flushing toilets. The problem is probably the flush tower that is in the center of the tank. To remove you would remove fill valve tube[the rubber tube] and then the very top where the the tube was will turn off ,turn counterclockwise, then the tower will lift off and install new. Pretty easy. SHUT WATER OFF BEFORE WORKING ON TOILET. Now to get the parts to repair you can look Mansfield up on the internet and they will send you the parts usally for free. I hope this helps. Good Luck!

Re: OT Mansfield toilet hard to flush question

#4

LRSmith

Re: OT Mansfield toilet hard to flush question *LINK*

LRSmith

A Google search turned this up:


Possible solution.

Re: OT Mansfield toilet hard to flush question

#5

Re: OT Mansfield toilet hard to flush question

Hal

I had one of those in another house. Got the tube/tower at a local plumbing supply place. Less than $10 as I recall. As I remember, all I used was the gasket which eliminated a lot of work. Worked just fine after that. When you get the new part, you will be able to figure out the easy way to do it. Good luck. Hal

Re: OT Mansfield toilet hard to flush question

#6

Re: OT Mansfield toilet hard to flush question

Hal

P.S. First I tried slipping the old gasket up on the tube and cleaning and "massaging" it. That worked for awhile, but the old gasket was too far gone. The permanent fix wasn't difficult. Hal

Re: OT Mansfield toilet hard to flush question

#7

Thanks everybody, we have success, mostly

Barry Irby

I went to Lowe's and bought the red rubber gasket ($1.86) and the complete repair kit ($7.98) just in case.

Replaced the red rubber gasket. The rubber gloves were a good idea, the black gasket below it was very "inky". It worked. Had to clean the bottom of the cylinder very carefully. I will be returning the kit. ( I used to keep and store such things, but now I store them at Lowe's. They do a much better job of inventory than I do.)

Probably should have replaced the filler valve while I was at it, but that's a different day.

Thanks for the help.

Re: OT Mansfield toilet hard to flush question

#8

Another question while we are here(OT)

Larry in nw ohio

Since you brought up "inky", Why and where does this come from? I really hate that stuff, is there any way to prevent it. Thanks. Larry

Re: OT Mansfield toilet hard to flush question

#9

Re: Another question while we are here(OT)

john mccullough

Our local water authority says that manganese collects on the interior of supply line iron water pipes. If pressure drops in the line the manganese drops into the water in larger amounts. This is common when fire fighters use the hydrants. Any pressure drops increases the mix and some ends up in your toilet.

Re: OT Mansfield toilet hard to flush question

#10

Re: Another question while we are here(OT)

Barry Irby

What I was talking about was black rubber parts deteriorating over time and when you touch them you get black sooty deposits on your fingers. I assume it is the carbon out of the rubber as it beaks down. Its hard to wash off. I have no idea how to stop it but it might work to coat the rubber parts with something like Vaseline when you put them in.