Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Router table build allmost done

Posts

Router table build allmost done

#1

Bob

Router table build allmost done

bob

OK It seems I was unable to post photos because of my cookies so here are a few of the ones I took. Next I will install the rest of the draws and make the draw fronts from pieces of scrap Oak I have laying around the same as the face frames.




Re: Router table build allmost done

#2

Re: Router table build allmost done

Dave Nichols

Great looking router table, you can be proud of it.

Re: Router table build allmost done

#3

Re: Router table build allmost done

Joe in a Cleveland suburb

Very nice.

Sure beats my piece of MDF with a hole cut in it...

Re: Router table build allmost done

#4

Re: Router table build allmost done

Larry in nw ohio

Yes Bob that is a great looking router table, puts mine to shame. If that would be in my shop it would be more of a work bench. Just how big is it? Larry

Re: Router table build allmost done

#5

Ri-i-ight

Mark Mandell - Gone Round In New Jersey

So, you want us to believe that you're actually going to use this piece of furniture in your shop?

You're going to get sawdust and chips and rub marks all over this, eh?

Yo, we didn't just fall off some turnip truck last night, you know!

[Nice job. Enjoy :D ]

Re: Router table build allmost done

#6

Re: Router table build allmost done

John Lucas

Bob It's looking great. I envy you people with that much room around your equipment. I'm starting to think a basketball arena would be too small after I owned it for a year or more.

Re: Router table build allmost done

#7

Bob

Re: Router table build allmost done

Bob

Thanks Mark, its 49" X 25" table with a JessEm Lift. It has 3/4" & 1/4" T- tracks and a Pinnical 36" fence I picked up at woodcraft for $50.00 on close out.

Re: Router table build allmost done

#8

Bob

Re: Router table build allmost done

Bob

Thanks Joe, Im sure you turn out great work on it though.

Re: Router table build allmost done

#9

Bob

Re: Router table build allmost done

Bob

Thanks for the compliments everyone I hope it lives up to your high esteem .

Re: Router table build allmost done

#10

Re: Router table build allmost done

George Colonel's Workshop-Havertown PA

Good Afternoon Bob,

I am frankly envious of the size of your table, and the ample space you have to allot to it. It should prove versitile in use, especially with the router lift. I also have one and like it immensely. Good luck with the dust colection. My cabinet is configured for DC, and it sucks. I also draw dust from the fence, but find a shop vac to be most effective. Nice job on the design and constrution.

George

Re: Router table build allmost done

#11

Bob

Re: Router table build allmost done

Bob

Thanks George, it's occured to me that the DC in a router table may not only serve as a way to get the dust out of the box below the router table, but more to cool the motor. The heat build up is in a confined space and can not dissipate as it does when moving it free hand, plus the outer body acts as a heat sink. So I think its good to keep the air moving even faster using a dust port with a blast gate so you can regulate it to have the maximum needed at the fence yet enough to keep the motor cool.

Re: Router table build allmost done

#12

Re: Router table build allmost done

Jason Waters

Nice Job.