Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Drill Press Upgrade,

Posts

Drill Press Upgrade,

#1

Drill Press Upgrade,

George Colonel's Workshop-Havertown PA

Good Afternoon Friends,

I have all sorts of shop made tables and drill press jigs, but realized last week that I needed a cross slide vise. After looking at the many available, I chose the Palmgren 3 inch, and bought from Amazon.

While it is a better made and more accurate tool as compared to the HF 5" cross slider I use on permanent mount at the front of my mortiser, it certainly was not adjusted correctly "out of the box". I fiddled with it for about a day, put it back together. Still imperfect, but aadjustments are good enough to complete boring holes in some hand screw jaws needed to complete three kits. Now I can look foirward to Pinewood Derby time, and other projects requiring a higher degree of accuracy. I shoulda dunnit years ago.

George

Re: Drill Press Upgrade,

#2

No more sliding by, eh?

Bill Houghton, Sebastopol, CA

Sounds good, Col. You'll no longer have a reason to be cross.

Re: Drill Press Upgrade,

#3

Joe Bradshaw

Re: No more sliding by, eh?

Joe Bradshaw

I guess that you put the squeeze on it Col.

Re: Drill Press Upgrade,

#5

Re: Drill Press Upgrade,

John Veerkamp

Don't press it folks.

Re: Drill Press Upgrade,

#6

Ain't

Mark Mandell - Gone Round In New Jersey

that the hole truth!

Re: Drill Press Upgrade,

#8

Ellis knows that what goes around...


Re: Drill Press Upgrade,

#9

Indeed--he knows the Drill.


Re: Drill Press Upgrade,

#10

Good point - a sharp comment!

Bill Houghton, Sebastopol, CA

I hope we're not boring the Col. with all these replies to his innocent post.

Re: Drill Press Upgrade,

#11

I would bet he enjoys the twists 


Re: Drill Press Upgrade,

#12

some funny replies but here's what I use *LINK*

John Lucas

I went through 2 of the cheaper cross slides sold in wood working magazines. Even modified they still don't work for all things. I wanted to be able to do some light milling kind of mortising as well as using it to just perfectly align holes. By adding a decent low profile vise or simply clamping the wood to the table I have been able to do all sorts of fun projects. It's heavy however so better do some curls and back work to loosen up before you throw this thing around


http://www.use-enco.com/CGI/INSRIT?PMAKA=201-2826&PMPXNO=951820&PARTPG=INLMK3

Re: Drill Press Upgrade,

#13

Jim DeLaney, Austintown, Ohio

Re: some funny replies but here's what I use *LINK*

Jim DeLaney, Austintown, Ohio

I have that same table, and it works quite well. Adding a low profile vise to it also works well. I have several, but this is a good example:


drill press vise

Re: Drill Press Upgrade,

#14

Ditto +

Mark Mandell - Gone Round In New Jersey

Mine tilts to 45° across the jaws.

Clamps to the table and used for metal work.