Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

1/3 hp motor question

Posts

Re: 1/3 hp motor question

#26

Re: 1/3 hp Dayton motor ( Grainger )

Bill Houghton, Sebastopol, CA

Hardly worth it for a 1/3 HP motor, Charlie. The outer diameter of a bushing is generally maybe 1/4" more than the diameter of the shaft; the outer diameter of a bearing (ball bearings are most common on motors, of the various bearing types) will be more like 1/2" to 1" larger than the shaft. You'd have to replace both end bells, assuming anyone made interchangeable end bells, and it would cost you more than the motor's worth.

I was just sorting out my storage shed today; I don't think I have any 1/3 HP motors anymore, which is too bad, or I'd offer to send you one for the postage costs. Mine tend to come from yard sales, where they're $1-5; but I know not everyone lives in an area rich in yard sales. If there's an electric motor shop in your area, you could probably find a used but serviceable motor cheaper than I could mail it to you.

Re: 1/3 hp motor question

#27

Re: 1/3 hp Dayton motor ( Grainger )

Charlie Lenz

Bill I can understand your thinking on the end bells, but that isn't the way it is with this motor. Because it has bushings, the end bells have a place to oil the bushings. When I pulled the bells I noticed not only the bushings with oil journals, but I also noticed that around the bushings is maybe a 1/2" all the way around the bushing is a felt packing to absorb the oil. I wish I had taken a picture when I had it apart so everyone could see it. But aparently it isn't worth it if I can't get anyone at Grainger to listen to me so I could get the parts. The motor with bearings retails for about $110.