Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Selling my contractor's saw

Posts

Re: Selling my contractor's saw

#26

Re: Before you all go ballistic on me ( Tom )

Charlie Lenz

Used isn't a bad way to go with any of the saws, but what may seem like a great deal to some may not be such a great deal if yopu don't know what to look for. For example, a 3 phase saw very likely came from a production shop, not would a person need to contend with a new motor, wireing and switch if you wanted it to run on single phase, but the bearings and arbor may be wore out. And what I mean by the arbor being wore out, I'm talking about where the blade fits over it. If it has some wear, the blade will have some play on it. Tom, what cabinet saw did you buy for $60, do you have any pictures of it ?

Re: Selling my contractor's saw

#27

Re: Before you all go ballistic on me ( Tom )

TomD

What I got that I do agree will not seem like a cabinet saw to everyone is a Beaver 9" saw. They are a jointmaking type saw, and with the right outfeed, etc... they could be a sheet goods saw. There are two versions, one of which is pressed steel base and the other is a the cast iron base. I have both. They are in the Rockwell delta family. Not a powerful saw, which I sorta like. I had a General 350 with a 3hp saw, and I found it too big for my work, and a little scary. I've been around table saws for 40 years, so I'm ok with a little power, but I also find my work is sometimes a little hairy, and I prefer a saw I can have control of. So it was perfect for me, I currently don't have it set up because I always wanted an INCA and I found one, but I am not sure it is actually a better saw.

The general 350 was given me by a guy who left for Oregon, and he left parts of his shop all over the place.

Re: Selling my contractor's saw

#28

Re: Before you all go ballistic on me ( Tom )

John in NM

In general, I've found that if a particular operation gives me the willies using a 5hp saw, it's just going to be worse on a 1 hp saw. Typically, I simply find another way of doing whatever it is that is scary with the TS, there's always three or four options if you think about it.

Just my take, YMMV :)

Re: Selling my contractor's saw

#29

Re: Before you all go ballistic on me ( Tom )

TomD

I don't find that myself. But I wouldn't do a dangerous operation under any circumstances. Just taking a shortcut in expression. What I do know is that over 40 years I have done things that turned out to be dangerous, like used pieces of wood that shifted, ended up being an unsafe dimension (can vary a little from saw or even blade to blade), or pinched the blade (Inca is my first saw with a workable riving knife, and it is a bit of a pain at that, though for sure staying in place.) When bad things happen the 3/4hp saw my dad has will stop turning and blow a breaker. The 3hp saw I had will drive the piece through you. While I won't take shortcuts, I do occasionally try something new, and you never know...

Motor power and gearing do mater. On the old machine tools, guys used to get totally wrapped up, or if they were lucky they had the dungarees ripped off them, and they would be left standing naked with a shocked expression on their faces. I'm not a gloves guy, but recently was wearing some while using a drill press. I got wrapped in, but was lucky it was a 7" model and I could hold my own till I grabbed the switch. If that had happened on my Biggun that came with a 5hp 3 phase, I would still be out there. I'm considering making some leather cowboy cuff so that my shirts and sweaters are under control.