Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

DIY tip for sander with vac / hose

Posts

DIY tip for sander with vac / hose

#1

DIY tip for sander with vac / hose

Keith Newton

One thing I like least about using a random orbit sander with vacuum hose, is the weight of the hose pulling down, interfering with my sensitivity / dexterity.

I like to keep things simple when I solve problems. This time it was so easy, I couldn't believe it. I found an old surf-rod, which hasn't been used in 25 years. Right now, it is wire-tied to an old grocery cart, which came with my shop when I bought it, that I use for moving small parts around from station to station.

With a snap swivel attaching the line about 4' down the hose, I can just reel in enough tension to lift the hose to the right working height, and the rod tip about 6' up, I gain enough movement through rod flex to have a good range of motion.

I'm thinking I probably could cut a big hole through a big block of wood, which could be dropped into the vice on any of the workbenches around the shop. This would make a quick rod-holder at each of those stations to add a little more flexibility to the setup.

Re: DIY tip for sander with vac / hose

#2

Your story sounds fishy


Re: DIY tip for sander with vac / hose

#3

JL

Maybe he's fishing for a compliment??

JL

:D

I wonder if it would work with a fly rod.

Re: DIY tip for sander with vac / hose

#4

Re: DIY tip for sander with vac / hose

Robin Corell in Atascadero CA

I used to do something similar for mounting adjustable desk lamps for task lighting, ie the block of wood in a vice or clamped to a table. I finaly drilled a hole in a jorgensen twin screw clamp. I like simple solutions too.

Robin

Re: DIY tip for sander with vac / hose

#5

Re: Walleye never heard of such a contraption 


Re: DIY tip for sander with vac / hose

#6

Eight hours before my first bite? %\],,,,,k

Keith Newton

I tried a spinning rod first, but it really bent it over too much.

Funny, after posting, I had lots of small irregular parts to sand, and the puppy / beast was playing with the part hanging down. This would have landed her in jail earlier, but it took all of the play out without affecting me, so I enjoyed the company.

Re: DIY tip for sander with vac / hose

#7

Re: DIY tip for sander with vac / hose

John McGaw

Wouldn't it be easier to just use a light flexible hose? The hoses which came with my Bosch ROSs weigh almost nothing and don't seem to get in the way at all as long as I tape the time to be sure that they are unkinked before starting.

Re: DIY tip for sander with vac / hose

#8

Kneale Brownson

I got hooked after almost a day!!


Re: DIY tip for sander with vac / hose

#9

Re: I agree with John