Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

OT - Maytag dishwasher problem

Posts

OT - Maytag dishwasher problem

#1

OT - Maytag dishwasher problem

Howard In Toronto

Our dishwasher started acting up Friday eve.

The process to wash dishes is to put a soap powder "pellet" into a container on the inside of the front lid and snap the container shut. During its washing, the container is supposed to open up and the powder pellet dissolve is supposed to do its magic on the dishes. The container doesn't strike me as any amazing piece of engineering - it's molded plastic, has a spring related to the hinge to open the thing during the cycle and a grommet to seal.

Well, that's not happening. The container opens but the powder pellet doesn't dissipate or get worn away at all.

Any ideas to repair the thing - it's not even two years old. Also - can't find the manual to it in case I want to phone Maytag! Aaaarrgghh!

Thanks.

Howard

Re: OT - Maytag dishwasher problem

#2

Re: OT - Maytag dishwasher problem

GolfSteve in Calgary

Clean it. Maybe there's some scale blocking the mechanism.

Otherwise take the door apart and replace the part. I did this on an old Bosch. Fairly easy job, about $50 for the part.

The difficult thing to diagnose is if the control panel is bad - you have to check if the controller is sending the electrical impulse to open the door at the right time. At the end of the day I just replaced the part and luck was on my side.

Re: OT - Maytag dishwasher problem

#3

If the door opens then the water

Dustmaker Mike

Should pull the pellet out. Are you sure you are getting water spraying around? You are correct in saying it is not rocket science.

Re: OT - Maytag dishwasher problem

#4

Re: OT - Maytag dishwasher problem

John McGaw

If the detergent dispenser door opens then it is doing its job, at least in part. If the pellet (I don't use them, preferring old-fashioned powder) isn't dissolving then the batch of pellets might be defective (started a new box recently?) or the dispenser door might be opening too late in the cycle for the pellet to receive sufficient wet time or the water might not be hot enough although you'd surely notice that. I'd try dissolving a pellet in a dish of hot water to see what happens before doing anything else.

There is little to the dispenser door release mechanism and usually it works or it doesn't. The operation is initiated by a 'wax motor' inside the door -- an electrical heating element heats and melts a plug of wax which expands pushing the latch open. This has been the method of choice on dishwashers forever more because it is cheap and simple and reliable.

If Maytag hasn't changed their ways then there may be a folded-up piece of paper taped inside the access panel or near the electrical connection which tells you how to initiate the test cycle and to interpret the results. Otherwise, the model number, inside the front top near the seal, should be enough for you to look it up online and download a manual in PDF form.

Re: OT - Maytag dishwasher problem

#5

Re: If the door opens then the water

John McGaw

I had completely overlooked the no water/no spray possibility. Checking that the tub is filling is pretty easy by simply opening the door after the cycle has started and looking. The wash spray should be clearly audible in even the quietest dishwasher and if that fails then it should be obvious if everything inside is wet evenly.

Re: OT - Maytag dishwasher problem

#6

Re: OT - Maytag dishwasher problem

GolfSteve in Calgary

Sorry, didn't read your note well enough. If the door opens and the pellet doesn't dissolve, then the pellet must not be getting wet.

Re: OT - Maytag dishwasher problem

#7

Most likely

Lee Schierer McKean, PA

Since the door is opening, most likely you are not getting good water flow through the pump. This can be caused by gunk (technical term for garbage) in the intake screens for the pump or clogged spry nozzles. The lower spray arm is easy to check as it usually had a large nut that screws off so it can be cleaned. Look at the openings to see if they are clogged. Also make sure it is free to spin when you put it back on. Check the pump performance in mid wash cycle by suddenly and quickly opening the door. You should see water every where inside. Check the strainers around the base for food debris, container labels etc. Most likely you will find clumps of stuff.

Finally, check the water temperature. If the water is too cold the pellets won't dissolve.Your water should be at least 140 degrees inside the dishwasher. It may be a sign that your hot water heater has failed.

Lee

Re: OT - Maytag dishwasher problem

#8

Be aware of phosphates

paul in AZ

Any clogging of spray nozzles or other parts of the system could be because of prior use of new generation powder detergents. The old stuff contained phosphates and worked well. They quietly introduced phosphate-free powder detergents a year or so ago. The new versions have no phosphates and leave a hard white powder-like film on interiors, dishes, silver, the pump and nozzles. It buggered my Bosch to the point that the cost of replacement parts was high enough that I got a new machine.

The pellets work great even in the mineral loaded water we have here.

Re: OT - Maytag dishwasher problem

#9

Re: OT - Maytag dishwasher problem

Larry in NW Ohio

Howard If you tried everything that has been posted and I know this will be very ovious but is there a wrapper arounf the soap you put in, that sometimes that needs to be taken off, if you didn`t, DAMHIKT.LARRY

Re: OT - Maytag dishwasher problem

#10

Re: OT - Maytag dishwasher problem

Dick Coers

We have really hard water and no softener. The best thing we do for the dishwasher is run vinegar through it. If we don't do that often enough, the dishes don't seem to get clean. Dump in a cup or so with every wash, or run a cycle every couple of weeks with no dishes and a couple quart of vinegar. Cleans it right up, and makes all the mechanicals work better.

Re: OT - Maytag dishwasher problem

#11

Ellis Walentine

Wow, thanks for that tidbit

Ellis Walentine

I wondered why we were getting that white stain on everything. I'm going to try the pellet method and see if that helps. Do you have a favorite brand? Are these *not* phosphate-free, or else why do they do a better job?

Ellis

Re: OT - Maytag dishwasher problem

#12

Re: Had a similar problem recently

Larry Clinton At Frankfort, (Central) Indiana

with our Bosch DW, We were using the "Calgon Gel Style" detergent. The dispenser door was just opening about 1/4 or less of normal. After cleaning the diswasher with vinegar and citric acid powder, I still had to remove the cover (door) from the dispenser unit - it was caked with the white deposit mentioned before. I tried to dissolve this scale with just about every cleaning agent I had including Vinegar, citric acid powder, CLR, Limeaway etc. None seemed to touch it. I ended up scraping the deposit clean with a sharp pocket knife. Then I went on the web and researched the issue. Seems the Gel detergent is not really good to use in hard water - powder style was recommended. I also found several sites that stated that all the DW detergents have a fairly short open life and you should buy small boxes (useable in a couple weeks) or the product degraded. We are now using powder and continue to use the dishwasher cleaner product that you hang in the unit and run a cycle - we have used this for a couple of years and it does keep the stainless tub and door shining so guess it helps.