Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Machine Oil?

Posts

Machine Oil?

#1

Machine Oil?

Thomas Skaggs, Foothills of Mount Level

I need to get some oil to lube my big machines (planer, jointer) Been a while since I bought any. Are there any new products you'd recommend?

Thanks,

Tom

Re: Machine Oil?

#2

Oil?

Bill Tindall

I have never oiled a planer or jointer. Nothing on either of my machines that would desire oil.

Re: Machine Oil?

#3

Re: Oil?

Jim

I have a Parks planer and the infeed / outfeed rollers are in bushings with oil cups.

I use a light weight 10W non detergent motor oil.

Works fine for me. Any lighter and it leaks past the bushings too quick.

Jim

Re: Machine Oil?

#4

Re: Oil?

Howard Acheson

Does your manual call for 10 weight oil? Most machines use 30 weight machine oil. 3 and 1 sells a 30 wt non-detergent machine oil that I have used on motors and tools over the years.

Re: Machine Oil?

#5

Re: Oil?

Jim

Howard

You are right, the manual does call for 30 wt oil

However

I have used the 10 wt oil as that is what I had and it seems to work OK

But

I should have checked the manual before I responded

Another "look before you leap" moment!

Re: Machine Oil?

#6

Re: Machine Oil?

Ken Oakley- Sunny St. Cloud, Fla.

I like Olive oil and a bit of vinegar on my salads.

Re: Machine Oil?

#7

Re: Machine Oil?

Robin Corell in Atascadero CA

from all that I have read non-detergent 30wt is still the prefered oil lube for oilite bearings. Thats what I use in my spindle sander as well as for the bushings on my Parks planner.

Robin

Re: Machine Oil?

#8

Re: Oil?

Robin Corell in Atascadero CA

In addition to the four oil cups that need attention there are also oilite bushings on each end of the bed rollers. I pulled mine apart and drilled 1/32" holes in the blocks that hold them so I can oil the bushings from the top of the bed without removing the rollers. The saw dust that settles in the holes acts as a wick for the oil.

Robin

Re: Machine Oil?

#9

Thanks!

Thomas Skaggs, Foothills of Mount Level

I appreciate the input. Just happen to have some 30 weight in the shed!

T.