Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Sweet shop music

Posts

Sweet shop music

#1

Sweet shop music

Carol Reed

as in a sharp plane singing along the edge of a piece of wood. Today I spent a little less that two hours setting up a Worksharp and tackling three planes and my badly mutilated abused bench chisel. I think I will like the Worksharp. It has its limitations but all in all it is a worthy addition. I also got 2 card scrapers sharpened.

The ol' bench chisel took longer to clean before I could sharpen it. Then it needed its back flattened, edge squared, ragged edge ground straight and flat and then sharpened and honed the bevel and how sweet it is!

I had gouged out a section of the front edge of my bench in moving it here. I cleaned up the gouge, flattened it, and glued in a patch. The freshly sharpened plane made short work of blending the patch in and the becnh front has a new edge.

I did this because I needed a sharp block plane and the card scrapers to finish the altar I am working on. They worked perfectly. Hope to shoot lacquer tomorrow.

Re: Sweet shop music

#2

Re: Sweet shop music

Larry in NW OHIO

Carol I hope you post pics of your alter. I would really love to see it. Larry

Re: Sweet shop music

#3

Aint' it satisfyin'

Ray - Middletown, IN

when you have a good day in the shop.

Ray

Re: Sweet shop music

#4

Re: Aint' it satisfyin'

Carol Reed

Oh, yeah!

And today that freshly sharpened LA block plane did a slick job on end grain. And the card scraper made some glue joints absolutely invisible. Love it when that happens.

Re: Sweet shop music

#5

Re: Sweet shop music

AZ in Colorado Springs

I bought a worksharp 2000 about two years ago. It's been a great little machine for me. It's soooo nice to have sharp chisels.

A couple of months back, one of the woodworking magazines had a reader tip about making a stand for the work sharp so there is a "shelf" behind and flush with the top of the sandpaper disk. So, I can use a honing guide to sharpen plane irons. Superb!

Also, with this stand, I have simply cut a piece of wood at 25 degrees and secured it with double sided tape to hone a chisel that wouldn't fit into the honing guide.

Re: Sweet shop music

#6

Re: Sweet shop music

Ronster

That sounds like a great idea. Can you point us at the location of this tip for further particulars or do you have pics to share involving your implementation of it?

Re: Sweet shop music

#7

Re: Sweet shop music

AZ in Colorado Springs


Here is a photo of the stand that I made. The tip I mentioned was in Woodsmith, vol 33, issue 97.

Re: Sweet shop music

#8

Excellent; much appreciated; I'm doing that!