Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

On cut lists, calculating and making measurements

Posts

Re: On cut lists, calculating and making measurements

#26

Insurance & Dress Rehearsal

Bob Lang

I use them more often then not, especially if the piece is complex or contains angles other than 90 degrees. I look at measuring as an opportunity to have a dumb*$$ attack, if I can reduce the number of times I measure to make a mark I'm a lot safer from myself. With angled or curved work, it is far easier to make the layout once, then have a reference for marking the real parts (and seeing how close I came to the plan after cutting).

It does take a little time, but I believe it saves time in the long run, and it's a good opportunity to review how things ought to be before cutting anything important.

Bob Lang

Re: On cut lists, calculating and making measurements

#27

Re: On cut lists, calculating and making measureme

AZ in Colorado Springs

I remember that article. I like the cutlists in the magazine because sometimes it is a bit unclear from the text what parts and pieces they are referring to, or may have glossed over.

I agree that cutting everything to size shown on the cutlist is a mistake.

I also liked the comment by one of the posters that more experienced craftsmen have less need of cutlists. I think in the final analysis, the key is for each person to find a method of organization that suits him (or her).

Regarding story sticks, I've used them only twice, in a repetitive construction situation.