Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

TV Antenna Question/Problem

Posts

TV Antenna Question/Problem

#1

TV Antenna Question/Problem

Thomas Norton

We have this antenna

http://www.usa.philips.com/c/tv-and-monitor-accessories/uhf-hdtv-digital-indoor-outdoor-sdv2940_27/prd/

And all of suden we stop getting a bunch of channels. We have rescanned but we cannot get the channels we had before.

Any thoughts? Do antennas go bad?

Re: TV Antenna Question/Problem

#2

Re: TV Antenna Question/Problem

Lee Schierer McKean, PA

It appears to possibly be a directional antenna, if so rotate it and see if the signal strength gets better.

Or it is possible that the plug at the bottom has come partially loose and you are no longer getting a good connection. Is there a power source for this antenna? If so is it getting power?

Had any thunder storms recently. You might have taken a hit that took out the antenna.

Lee

Re: TV Antenna Question/Problem

#3

Re: TV Antenna Question/Problem

Larry in NW OHIO

You probably have a loose connecting somewhere along the line. If as Lee said you check the plug inns and such. Go around all the connections from top to bottom. If I had to bet, I would think at the antenna may be the problem, that something came loose there. If the antenna is in good shape yet,like no broken pieces,then it should be OK. Be careful. Larry

Re: TV Antenna Question/Problem

#4

Re: TV Antenna Question/Problem

John McGaw

Antennas go bad and electronics go bad and cables go bad and connectors go bad but most often with a simple device like this in the home the problem is a loose connection. Your antenna (I have one too although I'm not using it) is in reality a minimal amount of antenna boosted by an electronic amplifier. The amplifier is fed by a tiny power dongle that inserts power into that little silver box which then feeds power up to the antenna through the same cable that feeds the signal back down.

Has anybody done anything with or around the antenna or cables or the place where the power dongle plugs in? If anything has been disconnected while hooking up something else (some Christmas gift perhaps) then that might be what caused your problem. The little silver box is direction sensitive and the antenna has to be hooked to the proper jack despite them being visually identical. After checking all of the connections and power it might be time to start suspecting that the amplifier inside the antenna housing has gone bad. BTW, if you have a meter you should be able to measure 6VDC at the end of the power cord from the power dongle.