Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Fireplace (OT)

Posts

Fireplace (OT)

#1

Fireplace (OT)

Larry in nw ohio

First off Barry I just got the E6000 glue and I think I have a piece of plastic from a rain coat. It has a small, 2x2", inside up by the collar that I think I can use.

Well now for the real question that everyone came here for. My Daughter and SIL has a gas insert fireplace. It worked last year but they can`t get it started this year. They have a pilot flame and it hits the thermocouple like it is suppose to and the other thing, I think it was called a thermopile. We have no manual for it so we are pretty much running in the blind sort of. I worked on something like these when I was working yet. But this thermopile is something new. The best we can figure out for now is the valve is not opening. It does have power, I just think the theromocouple isn`t sening a signal to open the valve. Does anyone have any other ideas? It`s a Majestic made by Monessen hearth systems, and I cann`t even find a phone number on the web site. Any help AT ALL. Thank You for any advise. What is that thermopole, if that is what it is really called, I`ll have to find that parts web site again. Larry

Re: Fireplace (OT)

#2

Re: Fireplace (OT)

Bill Houghton, Sebastopol, CA

Our gas "woodstove" - like a fireplace but freestanding - has two thingies in the flame of the pilot. One is a safety that won't allow the pilot valve to open unless there's a flame (there's an overrride button on the gas valve that allows running the pilot until it's hot enough - this is fairly common practice on appliances with pilots), the other is a micro-current generator that powers the thermostat.

Ours is a brand no longer imported to the U.S.*, but I've been able to find a company that supports it for parts.

If the pilot will run on its own, you've probably got a bad microcurrent generator - assuming you've got a thermostat of some sort on the fireplace. The hardest part of this, in my experience, is getting the part; I once had this part go out on our forced-air heater right before my brother/sister-in-law were due for a visit, and installation took less than the half-hour it took me to drive to the adjacent town to get the part. You might see if you've got a local appliance parts store, and ask them if they can help. If not, Google your fireplace make/model with the word, "parts." I bet you can find a supplier that will give you good service and the part.

*Although the company's still in business - it, along with another brand, is owned by Stanley, famed for its garage door openers and, oh yeah, a handplane or two; and Stanley decided to stop competing with itself and sell only the second company's products in the U.S.

Re: Fireplace (OT)

#3

Re: Fireplace (OT)

Bill Turpin in WNC mountains

If your pilot light stays on, then the thermocouple is good. The thermopile is an internal cluster of thercouples that generates some 30 times as much voltage. It is still less than 1 volt DC. Clean all the terminals of corrosion. Probably 700-900 millivolts DC. Check with a meter. If you have voltage then check the thermostat and wire. Rodent chewing can kill the system. Here is some help:

http://www.hearthsidedistributors.com/Catalog/Replacement-Parts-for-FMI-Products

http://www.monessenshop.com/buy/pc/Fireplace-Ignition-Systems-d3.htm

http://www.bizrate.com/fireplace-accessories/monessen-hearth-parts/

http://appliances.pricegrabber.com/monessen+hearth+systems+replacement+parts/results.html

Have fun!

Re: Fireplace (OT)

#4

Re: Fireplace (OT)

Larry Rupprecht

Had a similar situation (I think) with a Cozy Heat unit. Everything was correct but no ignition occurred. Local rep suggested giving the on-off rocker switch a fast snap-on motion....theorizing the current was just below threshold to ignite. Tried it and it ignited. Seems the current available through the rocker switch is close but sometimes a bit short of the amount needed for ignition for that igniter.

Ultimately, the cure is to replace the ignition module although I have not had to do so yet.....snap-on is still working but a "casual" motion doesn't cause ignition.

Hope this helps.

Re: Fireplace (OT)

#5

Re: Fireplace (OT)

Larry in nw ohio

Thanks Bill that gives me a lot of good info. I`m assuming the micro generator thingy powers the thermostat that would be on the wall somewhere to turn the flame up-down or maybe off when it gets to a certain degree. I don`t think they have a wall thermostat, but not sure. If not what else would it do? Also this thing is only a couple of years old, would these things go bad this quick. Larry

Re: Fireplace (OT)

#6

Re: Fireplace (OT)

andrew nistock

Had a similar problem after the stove was off all summer. The technician suggested blowing out the pilot head with compressed air. Do this very carefully(with the gas off of course) as the pilot head is fragile. Spiders seem to love to live in these things and clog up the orifice and you don't get a large enough flame to heat up the thermo-thingies. The technician also recommended leaving the pilot on all year but with the price of propane that ain't gonna happen. good luck

Re: Fireplace (OT)

#7

I did a google search- Lots their *LINK*

del schisler

http://www.google.com/#hl=en&cp=40&gs_id=2&xhr=t&q=Majestic+made+by+Monessen+hearth+systems&pf=p&sclient=psy-ab&site=&source=hp&pbx=1&oq=Majestic+made+by+Monessen+hearth+systems&aq=f&aqi=&aql=&gs_sm=&gs_upl=&bav=on.2,or.r_gc.r_pw.,cf.osb&fp=aa712503257bd70e&biw=978&bih=561


http://www.google.com/#hl=en&cp=40&gs_id=2&xhr=t&q=Majestic+made+by+Monessen+hearth+systems&pf=p&sclient=psy-ab&site=&source=hp&pbx=1&oq=Majestic+made+by+Monessen+hearth+systems&aq=f&aqi=&aql=&gs_sm=&gs_upl=&bav=on.2,or.r_gc.r_pw.,cf.osb&fp=aa7125032

Re: Fireplace (OT)

#8

Bart Goldberg

Re: Fireplace (OT)

Bart Goldberg

I had the same issue with Spider webs clogging the line. Also used compress air to clean out the line and now keep the pilot on all the time to keep from happening again.

Bart