Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Resawing Bandsaw questions again?

Posts

Re: Resawing Bandsaw questions again?

#26

Re: Now that you've set the record straight

Barry Irby

Inspite of my confusion over the Wood Turners blade I am still disappointed in the Wood Slicer blades.

We were very careful with them and wanted to saw pieces consistently at and 1/8". To get them we had to go to about 3/16" and we had to sand or dress about a 1/16 off the remaining stock. We had trouble with drift, barreling, and the blades just wandering. We fiddled with fence into better alignment for the drift, tightened the tension to the setting for a 5/8" blade for the barreling, and only got about fifty linear feet of resaw out to the blade. This was in clean dry stock. Tried to put the first blade back on the saw and could not adjust the fence for enough for the drift.

What I was hoping to learn from Wood Central is some idea of how many LF I should expect. I know that is like how high is up, but I used the blade up in a few days. Is that normal? Do I have outrageous expectations?

Re: Resawing Bandsaw questions again?

#27

Re: Now that you've set the record straight

wilbur

I can't speak to linear feet of resawing, but I do know that I have been using a 1/2" 3tpi Timberwolf blade for everything including resawing for at least the past 6 months, and I was able to resaw a piece of 8" red oak over the weekend without issues. I didn't quantify how flat the resaw was, but it only took about 4-5 passes over the face of the board with a jointer plane (not jointer machine) to get rid of the saw marks. The jointer plane that I was using takes shavings of about 0.005" or so, so a quick and very conservative calculation puts me about 1/32" of error.

Re: Resawing Bandsaw questions again?

#28

Re: Now that you've set the record straight

Jesse Cloud

OK, I'll stick my neck out and offer some quantitative experience - and I suspect lots of folk do much better...

First, the problem is that since all your finished veneer needs to be the same thickness, unless you are throwing away bad pieces, the cleanup has to go to the lowest common denominator, e.g. you sand or plane the pieces down to match your worst (or next to worst) cut.

I resaw a lot of wood for bent laminations. Target thickness is usually 3/32 and if the lams are tapered, parts are planed down much further. Conservatively, I estimate 50 per cent waste - this includes initial milling to square the stock, kerfs, jointing between resaws, cleanup and loss due to unexpected interior issues. Sometimes its less. Since lams are bent, there is somewhat more waste than on flat veneer. Yes, sometimes when you do that dry fit bend, a piece will just blow up!

The fifty percent figure held pretty constant on the monster Italian SCMI bandsaw at school, professionally tuned by a dedicated tech, and my old 14 inch delta tuned by yours truly.

Probably not what you wanted to hear, but I hope it helps.