Re: Going to be building a new shed soon but have
TomD
"I am going to build me a 12x18 shed on a slab on grade foundation. I am wondering what next tool buys should be. I have a 10'' Unisaw, 9'' DeWalt Radial Arm Saw, 13'' Delta Benchtop Planer, Steel City Benchtop Mortiser, and a Jet DC1100 Dust Collector. I am looking at adding a 6'' Jointer, 14'' Bandsaw, and a 15'' Floor Model Drill Press. I am wondering are these good choices."
Those are good choices. If it were me, I would go to an 18" bandsaw, 8" jointer, and I could live with a smaller drill press. But a floor mount is a good tool if you have room. YOu have at best 1/3rd my space, and I think you could start to run up against it.
It is really hard to recommend, because the issues are very complex. I would get cheap good stuff off craigs, so you can dump anything you don't like anyway. It isn't as though the Chinese stuff is better.
I have an 8" jointer. It will get 11 inch boards planed flat. The 6 inch ones just aren't big enough for face jointing decent wood. Wood comes in specific sizes, it isn't infinite, what you need is determined by the size that furniture is. MUltiples of 8" are more appropriate. It just works out the 8" is a better fit, and does not take up significantly more space. BUT. I could live without a jointer. It depends a lot on your wood, but despite being a jointing Nazi, I find I can put 90% of it through the planer from the get-go. And much of the stuff I can't put directly into the planer, only needs the high points knocked off with a hand plane, or will not joint down to a useable piece anyway. In my opinion 6" tools are not for cabinet shops. They are basically edge jointing tools. I prefer to edge joint by hand, but obviously the 8" works for that too. So If I couldn't have an 8 I wouldn't bother.
Bandsaw is different. The 14" is the key market, and there are some awesome tools out there in that category. I found I could work around a narrow saw. Unlike bill, I did not find the ability to remove a chip wider than 14" all that important. But I did find resaw work is critical for real woodworking, turning, and lumber processing. Your method of work will determine, but I do not find the 14" all that limiting. I gave mine to my dad. I use it happily when I am over there, and what is available in todays market is so much better than what I bought. A serious 14 is a good tool.
I could get by without the larger floor mounted drill press but they seem to take less space anyway. I resold my Taiwan one after over 20 years for about what I paid for it. I would only buy a serious old world one. I have a metal shop one, Buffalo Forge. I also have a 35 dollar, tiny I got off craigs. They are real useful, even where very small. A mortiser and a mill are way more cabinetguy, but I have never been without some kind of drill press. Drill presses for me are one of the tools in the shop that have a siren call for bad practices. Be careful.
Once you are in a ground level shop, time to toss the desk top planer and get one that will hog 250 thou. The desktop ones are amazing, but real time wasters beyond a certain point. I have had three, but I wish I had my old 16" Busy Bee, that was a smooth powerful Taiwan machine. My current General, is OK.
Of all the tools you have, production or hobby. I would only really need a planer and a bandsaw. I mean these days I would always have more, they are basically free. But those are the real tools.
Also, while all tools are a combination of precision, and power. Tablesaws, jointers, are the only two where I really insist on first world standards of quality. Which does affect price, since neither is really on my A-list. I would only buy good ones.