Chain saws and stumps
Dustmaker Mike
Well a few weeks ago I pulled a River Birch stump from my front yard. Lets just say it was a lot bigger then I figured and it took longer to pull it then I figured it would, even with a termite digger. Well Monday I started pressure washing the dirt out of it so I could use the chain saw to cut it up into a lot smaller pieces. Monday I sharpen the Poulan 14" chain and start at it. I get a lot done but the sun decided it was time for me to stop working for the day. Yesterday I adjust the chain sharpen it again add gas and oil and away I go. The cutting started to get harder the closer to the core I got. I also noticed the bar would not track straight it wanted to drift to one side or the other. I figured it was a dull chain and a really hard stump. I did a touch up filing of the teeth and went to start cutting again. Then it happened, I watched as the saw just bounced off the stump. I shut down the saw to see what was up when I noticed the Raker teeth are higher then the cutting teeth I guess I sharpened it a bit to much. I will be getting a new chain today on my way home from work. Then maybe I will grind the raker teeth down or just recycle the chain. Lots of Fun around my driveway.
, and put it on your bar and see if the two trakes where the chain rides in are straight with each other. If not take a file to them and square them up and make sure the chain isn`nt to sloppy in the trake. Good Luck. Larry




