Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Drill press question

Posts

Drill press question

#1

Drill press question

Dave in Bryn Mawr PA

Drill press is Jet floor model. Was going to drill some plastic sheets - manufacturer says use high speed to minimize heat build up, i.e. quick drilling does that. Set belts for 3000 rpm and chuck fell out - never did that before. Why did this happen and how do I prevent it?

Re: Drill press question

#2

Re: Drill press question

john lucas

Can't imagine that high speed would minimize heat build up. I use low speed and specially ground drill bits for plastic. A steeper angle doesn't pull the sheet up as it goes through the bottom. Normal drill bit grinds do that. Some plastics try to melt even at moderately slow speeds.

I'm guessing the vibration of running at 3000 rpm is what made it fall out. I've only had it happen to me on a few occasions and I've had my drill press for 20 years or more. Put it back in and put a piece of wood on the table. Then press it in really go against the wood. I crank the jaws all the way in so it's pressing against the body of the chuck.

Re: Drill press question

#3

Kneale Brownson

Clean the tapers really well before reinstalling


Re: Drill press question

#4

Re: Drill press question

Alan in Little Washington (NC)

Check the taper and chuck for signs of galling or contaminants. Carefully remove (ream) galling if necessary. Make sure there are no contaminants on either surface and clean if needed before whapping it back on.

While not likely the cause of your problem, you should be using a bit with 60 degree (60-90) tip angle to drill acrylic or polycarbonate. Normal twist drills typically have a tip angle of 118 degrees (118 - 135).

Re: Drill press question

#5

Re: Drill press question

Larry in nw ohio

Dave Try this on a scrap piece of plastic, IIRC at work we use to run the drill in REVERSE and let the bit MELT it`s way through. It`s been awhile, that`s why I say try a scrap piece. If you do, let us know how it went. Larry

Re: Drill press question

#6

Plexiglas drill bits

Al Goldstein

Once you get your drill press together there are special drill bits designed for drilling acrylics. You can purchase them at any Plexiglas store or a plastics production shop. Mine were manufactured by Craftics Inc. 2701 N. Puilaski Road Chicago IL 60639.