Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Shelves version 2.0

Posts

Shelves version 2.0

#1

Moses Yoder

Shelves version 2.0

Moses Yoder

My friend has a collection of African artifacts that she plans on displaying on these shelves, with a large African necklace of some sort going in the center open area. I had to think about the comments from Ellis about the thickness of the shelves and decided to thin them down to 1-1/2". I think it does look better. The main reason for the thickness before was to install a wooden support system, plus I thought it gave more of an impact. If I use 1/2" steel rods into the studs I can make them 1-1/2" thick and still mount them. The shelves are 8" deep. Part of the reason I am doing this for her instead of just pointing her to the company I work for is the price. Our cabinet company would normally build a hutch for this wall that would cost from $15,000 to $20,000, and I can do this version for her for under $2500. So does this look better than version 1?


Re: Shelves version 2.0

#2

Re: Shelves version 2.0

roger lance

Moses....it for sure looks better than anything at Ikea.

Re: Shelves version 2.0

#3

JL

Re: Shelves version 2.0

JL

A thought. I've successfully used french cleats (as well as Z clips) to install shelving, mantels and cabinets.

A decently cut french cleat could adequately support the weight. If you made your shelves on the order of 2" thick, you could have a good "web" of wood above the french cleat. You could cut the initial kerf on the shelf at a 45 degree angle and then cut off the waste with table saw.

I've also used TimberLok fasteners to attach mantels. They come in lengths up to 10". I don't know if they would suit your application.

At any rate - thick or thin - both ideas have merit. It depends on what is going on the shelves.

Re: Shelves version 2.0

#4

Ellis Walentine

Sure looks better to me


Re: Shelves version 2.0

#5

yes, better

Bill Tindall

Lighting will be important for this installation.

Re: Shelves version 2.0

#6

Re: Shelves version 2.0

Barry Irby

They look better to me.

Years ago I made shelves that went all the way around the top of a room. The people had a collection of glassware they wanted to display and some baskets. I ran a strip abut 1 1/4" thick and two inches wide around the room and made the shelves hollow with a 1/4" top and bottom. Ran a 3 1/2" screw into every stud. Slipped the shelves over the cleats and put screws into them from the top where they did not show. The shelves could be removed by removing the screws. I was concerned about them sagging when I realized how heavy the glass ware was, but they did fine. Mine has a piece of rope molding along the front edge and it was installed in long lengths after the shelves were up. It occurred to me alter I could have used long screws in from the front into the cleats and cover them with the rope molding.

Re: Shelves version 2.0

#7

One suggestion

Bob Hackett

I`d urge you to evaluate how any shelf system works while including the intended light source.

More than once I have seen someone install what appeared to be an excellent idea on paper only to be disappointed once the lighting was turned on and they saw what effects the shadows from the shelves had on the objects being displayed.

That being said I think the thinner shelves are an improvement over the original plan.