Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Deck screws

Posts

Deck screws

#1

Deck screws

Larry in NW Ohio

I have to redo my deck a little. As I was takeing out the screws out I got looking at them and noticed that the screw has two different threads on it. After looking at it a little closer I also noticed that the threads on the bottom part is a right hand thread and the top part is a left hand thread. Now I could understand if they were both right handed or even if both would be left handed I could understand that. The bottom would pull the screw in and the top would pull the top down a little faster, but the top being backward from the top I can`t figure that one out. Can someone tell me why the top would be opposite of the bottom? I would think that the threads would just fight each other going in and coming out. I tried to find something about it in McFeelys but I didn`t see anything that would explain it. If there is something there I missed it. HELP. Larry >( >(

Re: Deck screws

#2

Re: Deck screws

Charlie Lenz

The machine type threads closest to the head of the screw are for when useing a composite decking such as Trex. What those threads do is pulls down the bulge that is normally left around the screw head. Prior to those scews people would usually have to come back and pound the bulge down with a hammer.

Re: Deck screws

#3

Re: Deck screws

Larry in NW Ohio

Charlie, I read something like that in McFeelys, but I wasn`t sure i was reading it correctly. Thank you Larry