L&V's coffee table (PICS) *LINK*
Hikmet C. Sakman Victoria, BC CDN
I have had these two sheets of spectacular maple burl veneers for around 12 years or more. I knew they were destined to be a table top. Finally the opportunity came along a few months ago, when my referred clients asked for a dramatic and large coffee table.

When bookmatched, these maple veneers looked like a topographic aerial photograph of a dry landscape. Whoever seen it, just mesmerized by it. So the credit is due to the wood, although I had to do some painstaking veneer work to get it all down flat, since it was badly buckled due to the nature of its grain. Also, bordering the maple center with Macassar ebony without any cross inlay, demanded precision jointing and I am glad it turned out flawless.


Legs are attached to 1 inch thick inner frame, then it is screwed to the bottom of the table top. It is a quiet heavy table, 4 legs alone weigh a ton.

My external flash did not work, so I'll take better pictures later on though these ones will give your "trained eye" some idea about the grain and construction details.

I must admit, it turned out to be way more work than I anticipated but at the end I think it was worth it.
It is 42"x 47" and 16" high. I didn't want to cut off and waste the maple veneer, so that's why it is not square. I sanded up to 400G and my own mixture of varnish is hand applied. Yes it is a satin sheen, and turned out very well. Usually I like larger surfaces sprayed, but I am glad I did not.
Thanks for viewing,
Chico...
Sakman Fine Woodworks





