Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

How would you remove these fasteners?

Posts

How would you remove these fasteners?

#1

How would you remove these fasteners?

Henry Higginbotham

I've had this old Walker-Turner sander sitting around for ten years or so, and need to clean it up, paint it, and maybe even use it.

The nameplate is secured by three fasteners (drive screws, I think they're called). I need to remove the plate before painting the casting. Anyone know how to get these things out efficiently?


Re: How would you remove these fasteners?

#2

You want to visit Old Woodworking Machines *LINK*

Bill Houghton, Sebastopol, CA

You have to register, but it's free. Then search the main (OWWM) board for "drive screws." You'll get more information than you ever thought you needed. Link below.


http://www.owwm.org/viewforum.php?f=1

Re: How would you remove these fasteners?

#3

Our Ol' Buddy . . .

steve mackay

Dremel ! Don't go all the way . . . just untill you can get a tiny flat tip under it and POP !

Worked all the time changing data plates around in my ARMY. Once you've got the plate off just drill the screw out.

("RADAR ! . . . change the numbers on that jeep !")

Re: How would you remove these fasteners?

#4

Left hand drill

Phil Joines

a bit smaller than the shank size. Be sure to center punch the head.

I've also (rarely) gotten them out with a pair of flush cut dikes.

Re: How would you remove these fasteners?

#5

Re: How would you remove these fasteners?

FredD

I wouldn't.

Don't remove the Label Henry, do this instead.

I have on several occasions did this with success.

Carefully wife on a film of Vaseline on just the label and any other part you don't paint on.

This prevents the paint from sticking and comes right off after the paint job.

FredD

Re: How would you remove these fasteners?

#6

Thanks, everyone

Henry Higginbotham

The screw at about 2 o'clock in the picture was already about 1/16" from being seated (hole not drilled deep enough, maybe?), so I tried working it out with locking pliers. I went at it carefully, I thought, but it finally just broke off. I suspect that means there's going to be no getting the other two out, either.

I may be scaling back the aesthetics of the restoration, taking Fred's advice on painting, building dust-collection hoods, and just making it a user. Looks like a well-built machine.

Re: How would you remove these fasteners?

#7

This is what has worked for me

Robin Corell in Atascadero CA

I have mostly vintage machinery and about half of it I restored so I have dealt with these devils before. If the holes were drilled all the way through a re-ground nail set will do the trick from the back side. If the holes do not go through this is the method I have had the most success with: Use a sharp regular screw driver (and by sharp I don't mean sharp like a knife but rather a nice square tip with sharp edges) and carefully place the screw driver against the base of the drive screw and as parallel to the machine as you can and still hold the handle and give it a couple of sharp taps with a mallet. Repeat this from the opposite direction and several other directions. Most of the time the drive screws will start to back out and can be removed with a pair pliers.

Another way I have had limited success with is to use a dremel with a metal cut off disc and grind a slot in the head of the drive screw. Then use a screw driver to unscrew it. This method works best on screws that are in great condition with little to no corrosion. When I unscew them I use a hammer at the same time to provide a bit of an impact driver effect.

Robin