Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Sander

Posts

Sander

#1

Sander

Larry in NW OHIO

I have an old 6x48 belt sander that is an AMF. Can someone tell me how fast that should run. Without the sanding belt on the pulley runs around 2000RPM. Would that be about right. This thing has to be one of a kind. I tried to slow it down but the pulley on the drive shaft has a pulley shaft size of, if your sitting down put your seat belt on so you don`t fall off, the shaft size is 19/32. Yes a19/32" 0f an inch. I even checked the other end, it`s the same. Larry

Re: Sander

#2

Getting The Shaft

Mark Mandell - Gone Round In Jersey

You sure it's not just 15mm? AMC was made in Taiwan, if I remember rightly. Pulley speed's going to be controlled by the motor rpm + small pulley rather than the shaft. How you measure the rpm? With a sander, as with the bandsaw, belt/blade speed in feet-per-minute is the standard. Since the 6x48 are all pretty much the same, check the specs on others for comparison.

Re: Sander

#4

Ellis Walentine

RPMs are about right

Ellis Walentine

2000 rpm is a reasonable speed for a drive pulley on a typical 6x48 belt sander. Usually those wheels are about 4" in diameter, so you're looking at a belt speed of about one foot per RPM, or between 2000 and 2500 SFPM. Years ago, some of the Taiwanese manufacturers introduced benchtop belt-disk sanders that were direct drive, 3500 rpm, motors. That is too fast for either sander function. A 1725 rpm direct drive motor works fine, or use a pulley ratio that produces a similar speed.

Ellis

Re: Sander

#5

Re: RPMs are about right

Larry in NW OHIO

Thanks for the replys. I never thought to use my digital calipars to give me the reading in MM. I`ll do that when I go to the shop later. Even at that I don`t think I`d find a MM pulley. I`ll try to do something with the motor pulley. The motor I have is a 1hp,1725RPM and the pulley`s are a 2" on the DRIVIN pulley the one on the sanding belt, and the motor has a 2 1/2". I checked the speed of the sanding belt pulley with a meter. The read out was around 2000RPM. So I think it`s very close. Thanks again. Larry

Re: Sander

#6

Re: Sander

Lee Schierer McKean, PA

So buy a 1/2" bore pulley with the desired outside diameter and bore it out to 19/32. If it has a key way you can file down the key to fit.

Either that or look for a 15mm bore pulley.

Lee

Re: Sander

#7

Re: Sander

Larry in NW OHIO

Does anyone know where I can buy metric pulleys? Thank you, Larry