Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Need spacer

Posts

Need spacer

#1

Need spacer

Larry in NW OHIO

I just got a Flap disc kit from Klingspor, but the shaft size is 7/8" and I need a 5/8. So I need to find a 7/8-5/8 spacer. Does antone know where I can find one. I looked in McMaster Carr but no luck. Also what are these really called when you want to look them up in a catalog. I know someone out in WC land can help. As always thank you. Larry

Re: Need spacer

#2

Re: Need spacer

Neal in San Jose

It is called an arbor reducing bushing, or just a reducer bushing (altho that will probably get a lot of hits for plumbing reducers). McMaster Carr doesn't list one exactly that size, but number part number 68885A61 goes from 1 inch to 5/8, so I suppose you could file it down to fit. An exact fit wouldn't be critical in a flap wheel. Grainger was no help.

Re: Need spacer

#3

Rick L

Re: No you don't...

Rick L

I assume you are using an angle grinder...

The flap wheel goes on an angle grinder and the grinder has a 7/8" step to fit your flap wheel. Standard on all 4-1/2" angle grinders. So you don't need a special spacer...

Re: Need spacer

#4

Try Tractor Supply if you have one near

Ray Thompson - Middletown, in

Get a bronze bearing of those diameters, should work fine. Won't work forever though.

Ray

Re: Need spacer

#5

7/8 is standard for angle grinders...

John in NM

Almost all flap disks and SiC wheels have 7/8 arbors. If you're putting a 4 1/2" flap disk on an angle grinder, there should be this backing washer kinda thing that has a 5/8 arbor hole and a step to 7/8 for centering the disk. The arbor nut has a similar step.

If it's for a bench grinder, you need a plastic sleeve bushing. Klingspor should have those - the place I buy grinder wheels from supplies the size you need with the wheel.

Re: Need spacer

#6

Re: 7/8 is standard for angle grinders...

Larry in NW OHIO

Give that man a cigar,John, I fianally messed around with it and found that the washer did have another "step" on it that was 7/8" and the disc fell right on. Thanks everyone. Again the "WC Collective" does it again. Larry