Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

drastic measures?

Posts

drastic measures?

#1

drastic measures?

Joe Shelton

I have an older Ridgid contractor saw, fitted with an Incra TS III fence. (This saw, built by Emerson, was first sold as a Craftsman; it briefly was sold by Home Depot as the Ridgid.)

If I tilt the blade, the motor's mounting plate interferes with the fence rail at about 30 degrees.

It appears to me that, if I machine a relief cut in the bottom of the rail, leaving both sidewalls of the rail intact but hollowing out a portion of the rail, I'll be able to tilt the blade fully. I'm almost tempted to leave it alone, and just forego the ability to tilt the blade, but that rankles.

Any opinions about this approach? If I do it, what tools and cutters should I use in aluminum?

Thanks for any pointers.

Re: drastic measures?

#2

Ellis Walentine

Sounds like a plan

Ellis Walentine

Joe, this sounds like a modification that should not cause irreparable damage to your saw, if I understand your description of the problem, and if it will not weaken any vital parts. It does make you wonder why they didn't design the saw with this clearance built in to begin with. I'd proceed with all due diligence, but that's me. It's your call.

Ellis

Re: drastic measures?

#3

Tools and cutters

Bill Houghton, Sebastopol, CA

Probably a hacksaw and some files, if I understand your description right; or drill bits.

Apply the usual rule on a hacksaw as far as number of teeth: at least three teeth per inch in the thinnest part of the material (although this is nearly impossible with thin material, in which case you just get the 32 teeth per inch blade).

Before you start cleaning up a cut with a file, rub some chalk on the teeth; this will facilitate cleaning out the aluminum chips later. Otherwise, they can stick and be a hassle.

If it turns out that the right tool to clean parts of the work out is your router, make sure you're using carbide bits, go slowly, and expect to be slightly nervous - it's scary the first time you rout aluminum.

Re: drastic measures?

#4

Wear Eye protection!

Barry Irby

Re: drastic measures?

#5

Saw OK, aftermarket fence

Dan Donaldson

I had one of those on a Craftsman saw at one time long ago, and as I remember, that fence has quite a large guide rail.

Re: drastic measures?

#6

Re: drastic measures?

Gary Camp, Bend, Oregon

I have an older Craftsman saw, the motor bracket is mounted on 2 rods that extend from the blade mount to the motor mount. There is some adjustablity in these rods. Longer belt, longer rods and done. Of course your saw is probably different. Still I would try to adjust or modify the motor mounts before I attacked the fence rails

glc