We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
It's not quite done but I have the pieces together.
The top is hard rock maple which was salvaged from a bowling alley. I need to plane the trim to the top, and add doors to the cabinet on the far side. As you can see I got the casters on, they work great.
This is probably the thing I'm most happy with. I was working on the deck (the open area below the top and above the drawers, it's intended as a place to put tools I'm currently using) and was looking for a pencil. I don't know about you, but I've spent a lot of time looking for pencils. So I figured I'd route a pencil groove in the trim.
It's a little thing, but I like it.
Again, much thanks to everyone who helped me out with this project.
Looking great ED, and that pencil groove is a great idea. Sometimes the smallest idea is the best. One thing about the wheels, if they set in one spot for a long time, they will develope a flat spot, maybe yo could move ot just an inch or so once in awhile to stop that. Happy days with your new tool. Larry
Ed, nice bench. Your pencil groove is a good idea as long as you always place them back there.
Several years ago I finally replaced the standard pencil with a mechanical lead pencil. They never need sharpening, so you no longer need to keep a pencil sharpener handy, and they make more accurate marks on wood. I have always worn a short length work apron in the shop and keep one pencil in the supplied front "pocket", which allows access wherever I'm working at the time. I also keep a second one on my wall bench with my paperwork and plans. I like the fine line they produce and haven't used a regular wooden pencil since.
with an electric pencil sharpener! A Real Woodworker sharpens their pencils with a jack knife or even a belt sander, or even just 100 grit sand paper.
Oh, wait . . those are No. 2 Ticonderogas in that picture. Well, THAT explains everything. S'matterwitdis, real woodworkers' flat pencils too big for ya? Uh huh, now the truth is out.
I keep several Pentel 0.5 mm P205 drafting pencils on the bench (so I can usually locate one). They make a line fine enough for laying out dovetails and other joints. Though on dark woods I use black gel pens because the line shows up better (it's reflective).
I've grown fond of wooden pencils, 3H and 4H. I've not used mechanical pencils because they seem to mush down so easily. So, do you use .5 or .7mm, and what kind of hardness.
I keep 3 small cans of pencils next to the bench with maybe 40-50 pencils. Cutting down would be good.
Seriously though I'm terrible with pencils. I have a drawer full near my work bench. I tend to lay them down, then I go to the drawer to get another one. Buy the end of the weekend there is a pencil laying near every machine in the shop.
I have a stack of drafting pencils but my favorite is the one Rockler sells. It is large enough to get a good grip on and with the little sharpener you can get a fine but strong point.