Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

New Woodworking Experience

Posts

Re: New Woodworking Experience

#26

Re: Another question - stretchers

Thomas Skaggs, Foothills of Mount Level

In my case there were some unique factors. The two slabs are over 1 1/4" thick and over 9' long. The natural edge leads the top to taper inward in the middle. So it is wide on the ends (supported by the trestle leg assemblies) and narrower in the middle. That geometry allows the middle to flex some. So I decide to add stretchers under the top, just a few inches away from the middle opening. They are about 1 1/2" X 2" and oriented edge-ways. That does the trick. Just enough supplemental support.

In your case the geometry may not require the same. You might start with dry fitting a normal trestle assembly and clamp the top on and check. If you feel it's needed, you can always mortise in for the extra stretchers. Good luck with it!

T.