Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

220 Switch Going on my Bandsaw?

Posts

220 Switch Going on my Bandsaw?

#1

220 Switch Going on my Bandsaw?

Ken Bellock (Houston, TX)

I have a MiniMax S45 band saw that is wired to run on 220. Since it got cold, I am experiencing problems on start up that I think is the switch. When I plug in the tool, I will hear a faint electrical buzz coming from the switch. This has always been the case with saw, but now that it's cold when I switch it on, nothing happens except the volume of the buzz may change. I remedy this by plugging the machine in, unplugging it, turning the switch on the motor on and off, and repeating both until I hear a magical click in the switch, and then I can operate the saw normally...

Any one experience this before?

Re: 220 Switch Going on my Bandsaw?

#2

Re: 220 Switch Going on my Bandsaw?

Mark Mandell - Gone Round In Jersey

Sounds like a dirty relay. Suggest you unplug it, remove the cover, blow it out with air, inspect the contacts, and (after recovering it) power up and try again.

Re: 220 Switch Going on my Bandsaw?

#3

Re: 220 Switch Going on my Bandsaw?

Larry in NW OHIO

Ken Along with Marks suggestion, which I think is the problem also, but while you have the switch open look at the contacts and see if they are pitted or carboned up. If so take some 320 or finer and just sand them very little, and blow it out again. Larry

Re: 220 Switch Going on my Bandsaw?

#4

I'll give it a try tomorrow afternoon.

Ken Bellock (Houston, TX)

Thanks for the suggestions, I'll open up the switch tomorrow afternoon and give it a good cleaning and check the contacts. I hope that fixes it. I love this saw!

Any reason why there are two switches on the saw? One on the motor and one by the table? Just curious...