Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

drum sander choice

Posts

drum sander choice

#1

drum sander choice

Jerry Gibbs

I am considering making my own drum sander. I am looking at the flat top drum below type (Sand-Flee) and the drum above (Performax). My question is how to get parallel surfaces, starting with a warped panel ( my speciality). Can you get flat, parallel, surfaces of uniform thickness with either type? How do you run a warped panel through the Performax type?

Re: drum sander choice

#2

Re: drum sander choice

Dave Paine

I have a Performax 16x32 and last year purchased a 30in wide "Flat Master" which is a much larger machine than the Sand Flea, but also has the drum mounted below the table.

Sanding a bowed panel flat will take some trail and error with either machine.

I made a sled for my Performax due to finding I was getting more material removed from the middle than the ends. I think a flat sled would help with a bowed panel on a top mounted drum machine like the Performax.

For a bottom mounted drum like the Flat Master, I would start in the middle of the board and sand to one end. Flip and so the same for the other end.

After using the Flat Master, my Performax is now just gathering dust.

A big advantage of a bottom mounted drum is lack of heat. The Flat Master uses a hook and loop attachment of the paper, and the drum is set to barely touch the wood when at rest. Turn on the machine and centrifugal forces expand the paper slightly, just enough to sand the wood. Works well. No heat, so you can sand paint, varnish etc, if needed.

With my Performax I had to frequently clean the roll to prevent burning. With the Flat Master I do not get any buildup.

Re: drum sander choice

#3

Re: drum sander choice

Larry in NW OHIO

OK Dave I`ll bite, what is a Flatmaster, do they have a web site? Thank you Larry

Re: drum sander choice

#5

Re: drum sander choice

Dave Paine

Jerry already provided the link. Happens to be located in Canada, but I did not have any problems with the cross border shipping.

If anyone is interested in the Flat Master, I can recommend the machine, but NOT the right angle fences. I purchase these, and they are made of thick steel, but the problem is mine are not orthogonal. Worse they are racked, so different off-90 deg angle at one end vs the other. I ended up having to make my own. Happy to mail these to anyone who does not need to sand edges at true 90 deg. :D

Re: drum sander choice

#6

too many http

Neal in San Jose

Remove one set of http:// to get the link to work.