Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

I want >20 min. of open time; glue choices?

Posts

Re: I want >20 min. of open time; glue choices?

#26

Re: I want >20 min. of open time; glue choices?

Mark Rakestraw

A lot of good info about glues here....Another way to save time when doing a glue-up with lots of loose tenons is to pre-glue the loose tenon into one or the other mortice ahead of time. Of course you have to be carefull not to contaminate the other joint surfaces with glue during this step, but that's not usually too hard to manage. It gives you a lot fewer parts and surfaces to deal with during final glue-up.

Re: I want >20 min. of open time; glue choices?

#27

One point...

John in NM

"Over the course of ~ 25 years of using epoxy for M&T joints, I have not ever had the need to ever take one of my pieces apart, and wonder how often others do when I read a lot of claims of the benefits of being able to do so. I guess I am just lucky maybe."

I don't think the concern comes from having to repair one's own work as concern for some future craftsman having to repair it. While I use almost every kind of glue available, I agree that this point is somewhat over rated, it doesn't hold much sway when I'm choosing an adhesive.

Researching and comparing the reversibility of various glues would make a good magazine article. Perhaps one has done it though, I haven't read any of the mags in almost 10 years now.

I've got some white epoxy that is amazing stuff. I think its basically the same as PC-11 marine epoxy (though mine are some high falutin scientific supply brand). Transtint dyes go right in and do seem to accelerate curing. I have experienced universal dyes slowing 5 minute epoxy cure though, and a vendor I buy urethane resin from and has long experience with it also cautions against the overuse of dyes. Just my experience, caution rarely causes problems even when its un-necessary. I've never found that I couldn't get the epoxy as dark as I wanted, more a case of finding what "just enough" dye is, and stopping there.

Ok, I guess that was two points :D

Re: I want >20 min. of open time; glue choices?

#28

Re: One point...

Keith Newton----Little Rock, Arkansas

Most of the time when I want to make the epoxy match my wood, I just mix some of the dust from my belt sander in with about three or four times as much colloidal silica. Just mixing the wood flower, comes out too dark, and is a lot heavier, which makes it prone to sag and run more than the light weight filler, which also contributes to better flexibility.

I think you can mix almost any kind of dry powder to epoxy without much worry. I have used universal tints, but only in small amounts, not being sure about the oil or whatever makes it liquid.

Re: I want >20 min. of open time; glue choices?

#29

That's right...

John in NM

I'm guessing the silica improves the opacity of the mixture, which keeps it from coming out too dark. Epoxy + wood dust alone is still translucent enough to capture light rather than reflect it, making it appear dark. I've never used the silica though, so I'm just guessing.

The powder will likely be inert, so you're right that it won't affect the cure. The thing I like about the transtint+epoxy is that it doesn't make the epoxy super viscous, so I have no problem filling small cracks and voids.