Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Cardle repairs

Posts

Cardle repairs

#1

Cardle repairs

Rich in MN

I built a cradle 5 years ago and it has been used for several babies. Now my daughter is expecting and they tried to put it together and found some the brass threaded inserts have come loose. Some one must have over tightened the fastners and spun the inserts.

What is the best way to secure them so that the cradle can be assembled and used?

I did a test with Gorilla Glue but it didn't hold.

Will an epoxy work or do I need to drill a larger hole and insert a dowel and make a new correct sized hole for the inserts?

Re: Cardle repairs

#2

Re: Cardle repairs

Larry in NW OHIO

Rich That is just what I would do. Drill a bigger hole, dowel it with an oak dowel and with glue, redrill it and put the insert in with epoxy. Larry

Re: Cardle repairs

#3

Think about what is going in the cradle

Gary Smyth

and make your choice.

Re: Cardle repairs

#4

Re: Cardle repairs

john lucas

Epoxy should work just fine. I glued many an insert into bows back when I was doing Archery. I've also repaired inserts that have been pulled out of pressed wood. The epoxy works quite well.

Re: Cardle repairs

#5

Re: Think about what is going in the cradle

Lee Schierer McKean, PA

I agree that a so so repair should not be considered. If you can't find a larger O.D. insert, I would drill out the damaged wood, inset a plug (cross grain or dowel) and then drill a through hole and use a carriage bolt with a nylock or prevailing torque locknut. You want to be sure the fastener holds the parts together.

Lee