Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Question on rebuilding a tile floor

Posts

Question on rebuilding a tile floor

#1

Question on rebuilding a tile floor

Barry Irby

I am remodeling a house. Tore out a ceramic tile floor to patch the rotted floor around the toilet. The floor now has 1/2" plywood over joists on 16" centers. Can I put one of the cement boards (Durock/Wonder Board) directly over that or do I have to put an additional layer of plywood? Or would you go back with 5/8 underlayment? We will be installing ceramic tile.

Re: Question on rebuilding a tile floor

#2

Re: Question on rebuilding a tile floor

Howard Norman

To my way of thinking the 1/2" plywood is too thin to support the backer board. I have used 2 layers of 1/2" plywood in the past under backer board myself without any problems.

Re: Question on rebuilding a tile floor

#3

Might

Mark Mandell - Gone Round In Jersey

If you could work in some extra blocking under the ply. You can also come up from below with some more ply glued and screwed into place.

Do not use Durock in this application; soaks up and holds too much moisture in horizontal applications. Hardibacker would be my choice.

I'd also consider a decoupling membrane like Ditra with Kerdi stripping at the wall/floor joints.

Re: Question on rebuilding a tile floor

#4

That's awful thin

Bill Houghton, Sebastopol, CA

If you're doing tile, you want minimum flex.

Re: Question on rebuilding a tile floor

#5

Re: Question on rebuilding a tile floor

Nat Robison

I thought I heard/read somewhere that 1" is the minimum (combination of plywood and tile backer) to shoot for but I think 1 1/4" feels much more solid. It's relatively easy to craft any transition you might need due to height differences between rooms.

Re: Question on rebuilding a tile floor

#6

Re: Question on rebuilding a tile floor

Larry in NW OHIO

Barry I to think 1/2" is to thin, I`d put at least another 3/4" on there. Also If this is a cool area the tile is going to be COLD in the winter. If so have you thought about putting floor heating down. We did when we redid our bathroom last summer. We just started using it a couple weeks ago, would not do without. LOVE IT Larry

Re: Question on rebuilding a tile floor

#7

addl. opinion

Nat Robison

When I put a new bathroom in my basement a few years ago, I put in electric radiant heating under the portion of the floor that gets the most foot traffic. I like it very much and without it, since this room sits on the basement slab, the floor would be quite cold. I went with a 3'x5' mat and the non-programmable thermostat and I believe the cost was around $250. Obviously, price goes up with the sq. footage of mat that you're buying. Only requires a 20 amp circuit to power it.

Re: Question on rebuilding a tile floor

#8

To answer one of your questions....

Nat Robison

I'm no tile expert but you can not just lay tile backer over joists. I'm pretty sure it has none of the load-bearing qualities of plywood, its main benefit is for adhesion of the thinset and tiles. The area around a toilet is going to get a lot of foot traffic and weight on it. I'd probably do some extra bracing, lay 3/4 plywood and then 1/2" tile backer. If the whole floor is torn up, maybe lay another layer of 1/2" around the whole bathroom and then 1/4" backer on top of that. Whatever way you choose, I'd shoot for 1 1/4" of ply and backer before tiling.