Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Making your own Drum Sander Sandpaper????

Posts

Making your own Drum Sander Sandpaper????

#1

Making your own Drum Sander Sandpaper????

Barry Irby

I have a Performax 16/32. A friend gave me some strips of sandpaper that appear to be perfect to make strips for it except they are too wide. About 5" instead of about 3". has anyone tried winding wider strips onto the drum? Or should I cut them down to size? Hate to cut off 40%. Or, If you can't wind 5", can you go the other way and wind 2" or 2 1/2" wide strips? I could cut them into a 2 and a 3 or two at 2 1/2". (These strips came form an very old surface sander he has where your work piece rests on a table that rolls in and out and you press the belt down to it with a felt block. The glue joint failed in the belts and rather than trash them, he gave them to me. Pack Rat talking here)

Re: Making your own Drum Sander Sandpaper????

#2

Re: Making your own Drum Sander Sandpaper????

Larry in NW OHIO

Barry I love your packrat ingenuity, being one myself. I see nothing wrong in using the 5", but I think it may be a little wide for a small dia. drum. I assume you have a 4" drum. So I would cut them to a 2" and a 3" and use them that way. It`s just going to take some playing around in the wraping them around. Best of luck fellow Packrat. Larry

Re: Making your own Drum Sander Sandpaper????

#3

Jim DeLaney, Austintown, Ohio

Re: Making your own Drum Sander Sandpaper????

Jim DeLaney, Austintown, Ohio

Pretty much what Larry said.

I have the 10/20 model, and use strips from a Klingspor "Bargain Box" that I cut/tear to width. The home made strips work just fine, and I figure cost me about 25� each, since the whole Bargain Box was only about 20 bucks.