Shop enhancement
Rod Peterson�Ormond Beach, FL
Aside from the 240V remote DC switch I installed a couple of months ago (on which I may or may not have reported), not much has gone on in my shop for a while. Until, possibly as an avoidance project against the bookcases SWMBO has been nagging me for, I finally got around to piping my shop for air.
In the Illinois shop, I had run galvanized pipe to three filter/regulators, plus a line out to the garage to another filter/regulator. That way I was able to keep the compressor at a location which was convenient (and quiet) yet still have air where I needed it. I had found, for example, that air in the garage was important for bicycle tires and air tools for the car, but compressor motors don�t crank well at -10°. Also, I theorized that the pipe itself serves as something of a manifold, thus providing more reserve air for those demanding sanding jobs I anticipated. Well, never mind all of that, in Florida I was tired of having a long hose permanently laying on the shop floor and wanted to be able to more easily vary the pressure (the brad nailer uses less pressure than the bicycle tires, for example).
Say hello to copper! I used copper this time mostly because in Illinois I had access to a Ridgid threading set. Also, I had perfected my copper sweating skills earlier in the remodel, which is reflected in the fact that I�m only losing a little bit of air, and that almost certainly in one of the regulators (not my fault). And how I wish I had bought my copper pipe about four years ago before the price spiked. Anyway, here are some shots of the result:

The location of the compressor (out of view below the tool chest) and the principal manifold on the east wall.

Closeup of the principal manifold. Shut off valve isolates the system from the compressor (attached by �whip�).

Detail of the secondary manifold on the west wall.

The main trunk line goes up in the south east corner…

…across the length of the shop (note the 1" in 4' pitch)…

…and drops down to the west regulator/filter.
I pitched the pipe because compressed air is naturally wet, and any condensate that develops will be able to flow to the far end. You'll note the drain fittings at either end of the system near the regulators.
The additional pipe works out to ≈ ½ gallon extra capacity, which isn�t much in the grand scheme of things, but given that it�s ¾" should permit pretty good flow on the west end, >30" from the compressor. That�ll accommodate my spraying, although I don�t know how much sanding I�ll do there. The big deal is being able to easily reach car tires—especially without having to stumble over a hose reaching all the way back to the compressor—and being able to regulate pressure out at the drop, also without having to go all the way back to the compressor.
Rod