Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

cedar chest

Posts

cedar chest

#1

cedar chest

Dan Andrews

I am a high school wood shop instructor and have a student that is planning to build a cedar chest with a self rising tray. Does anyone know where to find the hardware to install such a tray?

Re: cedar chest

#2

Re: cedar chest

Dick Coers

Here is a design that Rockler sells for jewelry boxes. It would probably not work for the chest, but would give him and idea of how to make one. I thought they used to sell what you are asking for, but maybe too many injuries from lids falling?

http://www.rockler.com/product.cfm?page=591

Re: cedar chest

#3

Re: cedar chest *LINK*

Alan in Little Washington (NC)

I did some searching and other than the jewelry box set from Rockler and other vendors, I did not see any large size lifts brackets appropriate for a chest. None of the chest restoration hardware vendor sites I checked had anything for lifting a trunk tray.

I've seen small sewing baskets like the one at the link below that have multiple trays that open to the left and right. They all work on the parallelogram principle so the tray(s) stays horizontal. I think your student might need to make his own own. It would be a good exercise in design, and fairly easy to do on paper to check the geometry.


Sewing basket

Re: cedar chest

#4

Agree, BUT:

George Colonel's Workshop-Havertown PA

Good evening Allan,

Perhaps the student should question the necessity of lifting hardware for a cedar chest tray.

Those which I have seen in other applications like jewelry boxes did not provide lost of unobstructed clearance neded to foor wide access to the storage unit below. For a cedar chest, commonly used for relatively bukly items like blankets, such an arrangement may be counter productive. Instead, a simple lift out drawer is easy removed and once removed, access to the lower storage volume is unrestricted. In my opinion, he's doing it the "hard way".

George

Re: cedar chest

#5

Re: Agree, BUT:

Alan in Little Washington (NC)

I agree, but we don't know what the student has in mind. Maybe after he reads these posts he will re-evaluate his needs and design. I think the best approach would be to use two 1/2 width top trays which would be easier to lift out.

Besides, a self-lifting tray would need some pretty substantial arms and mechanism, and if the user is like me, he will regularly pinch a finger or two in it!

Re: cedar chest

#6

What I Did

George Colonel's Workshop-Havertown PA

Good Morning Allan,

Mine was simple enough, but as one of the pix depicts, the lift out tray was "top drawer" ;)

George

Re: cedar chest

#7

Re: What I Did

Alan in Little Washington (NC)

Nice!

That pic answers the age old question . . . . Boxers or briefs?

Re: cedar chest

#8

Re: What I Did

Larry in NW OHIO

Colonel Be careful with your drawers, I see they have holes in them.Larry