Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Router Table Distances

Posts

Router Table Distances

#1

Router Table Distances

Dwain

I'm about to embark on building a router table and I was wondering could someone tell me what are the average dimensions from the center of the router plate to the front edge of the router table top and the distance from the center of the plate to the T-track.

Thank you,

Dwain

Re: Router Table Distances

#2

Re: Router Table Distances *LINK*

del schisler

go here and look at the demo. You can put router in the center or off set it. Depends on what you are going to do. Lot's of people do a over kill on the table.


http://us.oak-park.com/catalogue.html?list=RT01--

Re: Router Table Distances

#3

Re: Router Table Distances

George Colonel's Workshop-Havertown PA



Good Afternoon Dwain,

This is the second table I built, and was based loosely onb the AWW/Norm Abram design. The dimensions are 38.5" wide and 23.5" deep, and were completely arbitrary. I did place the router in the center of the width, but closer to the front of the table so I could "pop out"the router for bit changes. At the time of the table's design, I was using a P+C 690 router hung below a Rousseau plate. Subsequently, I modified the table to accept a JessEm Master Lift and my P+C 7518. The edge of the plate is 5 inches from the front edge of the table. I did not to install a T track, and use a sled against the commercial fence from Penn State Industries. Building your own table is a fun thing to do, but I do recommend a commercial fence. Good Luck with yours.

George

Re: Router Table Distances

#4

Re: Router Table Distances

Larry in NW OHIO

Great looking table, Colonel, it looks a lot like mine. I think it came from the same person, I`d have to look. I put formica on my top, the drawers are the same and in the front middle I have mine half covered with plexiglass. So I have to say great job. Larry

Re: Router Table Distances

#5

Re: Router Table Distances

Jim Dillon

Dwain,

As Chuck said, I don't think there is any standard for the distance between your router bit and the edge of the table. Pick something that feels good to you as you lean over the top at the height you plan to make it. I just measured my router table that is built into my TS top and the center of the bit is 8 inches from the edge of the table top. My Rousseau plate is 4 inches from the edge. I checked the stand-alone router bench that is described in Bill Hylton's Router Magic book (an excellent reference BTW) and the router bit is 8 inches from the edge, whereas his portable router table places the bit at 6 3/4 inches from the edge. I installed a miter slot but in all honesty I have never used it. I like to use a squared piece of wood butted up to my homebuilt fence to back up the routed piece and to prevent tear-out. Hope this helps.

Jim