Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

H.B. Smith 24'' jointer

Posts

H.B. Smith 24'' jointer

#1

H.B. Smith 24'' jointer

DAN LONG

Hi I am looking at buying a used H.B.Smith 24'' jointer that has been restored. I am not to familiar with them however I am familiar with their big sanders very high quality. I am wondering if the jointer is of the same quality. I do know it is direct drive 4knive round head with bearnings and not a clamshell head. also head has been balanced and table top restored also.

Thanks Dan

Re: H.B. Smith 24'' jointer

#2

Re: H.B. Smith 24'' jointer *LINK*

mdclor

You might be able to find out more about this jointer at the below link.

HTH,

Merle


Old Wood Working Machines

Re: H.B. Smith 24'' jointer

#3

Dan, I hope you are a big tough guy,

Keith Newton----Little Rock, Arkansas

made mostly of bone and gristle. I think surfacing a 24" wide board, feeding by hand would be quite a chore.

I used to wish for a larger jointer than my 12", but have found other ways to deal with stock that is too big for my equipment.

I have a Makita 6 1/8" power plane that I take to boards too large for my planer, that does a pretty nice job of flattening the big stuff.

I don't think I would have to sharpen 4 24" knives when mostly I used and dulled the first 8" to 12" of edge, while the other 12" only got occasional use. Just saying.

Re: H.B. Smith 24'' jointer

#4

Re: Dan, I hope you are a big tough guy,

DAN LONG

Hi Keith

right now I have a 16'' cresent jointer and it does do a great job a lot of times I wish I had a bigger one. My last project was a 7' round dining table. as far as pushing a 24'' board across it not a problem I have a power feeder for that. Plus i love those old machines and I like to restore them. My last project was a 48'' beech drum sander it was all rusted I took it all apart in the barn used electrolysis on all the pieces and now it is like new.

Thanks for your reply Dan

Re: H.B. Smith 24'' jointer

#5

Re: H.B. Smith 24'' jointer

Robin Corell in Atascadero CA

The shop where I did my apprinticeship had a 16" H B Smith jointer and a 34" H B Smith bandsaw. The bandsaw had wood rims and looked every bit its age but it was one of the nicest running bandsaws I ever had the chance to use. It was on par with a Yates or Oliver. The jointer had a new style 3 knife head but it lacked jack screws and was a real pain to change knives even using a magna set jig. As far as quality they are probably about the same as Crecent. The nicest quality jointer I ever used was a newer 12" Yates.

Robin

Re: H.B. Smith 24'' jointer

#6

Re: H.B. Smith 24'' jointer

DAN LONG

Hi robin

I just recently saw a article that said that fay&egan made there jointer after H.B. Smith and if that is the case it should be a decent one. I am probably going to get it. I know a while back (3yrs.) I had a chance to get a H.B. Smith sander for 300.00 but my trailer could not hold the weight and my truck could not pull it.Now I have the truck and need a heavier trailer.

Dan