Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

OT Have to do some Plumbing

Posts

Re: OT Have to do some Plumbing

#26

Re: PEX

Bill White

Scott and I share the same opinion. Pex or CPVC for me. I incurred $4,000 in repair costs to a slab-built home about 5 yrs. ago due to pin holes in copper.

They Pex/CPVC naysayers are probably the same ones who said that they would NEVER use PVC instead of cast iron.

Bill

Re: OT Have to do some Plumbing

#27

Now that's good advice!  I follow it too.

John E in SC

Re: OT Have to do some Plumbing

#28

too much fretting

Bill Tindall

If I "must" flush my house water pipes before usage would not the paranoid person also worry about flushing the supply to the house (in my case 1500 feet of 1" PVC pipe), and then the supply to the supply and maybe even the water storage tank that sits on the hill and supplies the town? And if I am going to fret about what may leach from my house pipes should I not add to my concern these external pipes and tanks of unknown composition?

While it may be entertaining to speculate that this or that could be happening, perhaps aided by some alarmist report on the "news", the evidence at hand suggests that drinking water from a convenient faucet is not a risk. I am happy believing someone has determined that what everyone, suppliers and consumers, does concerning water has been found to pose no unacceptable risk and I can worry about more important issues.

The problem is that if you can get your alarmist preliminary research findings into the news you can get a bigger follow up grant money. As a result we get bombarded by the nightly news with preliminary results like eating "Cherrios on Wednesdays saves your liver" (or cooking in aluminum pots causes Alzheimer). The followup research that debunks that myth gets buried in the Journal of Obscure Science.

Re: OT Have to do some Plumbing

#29

Re: PEX

Scott Greaves in Blackfoot ID

Hi Ron,

I've always used the manifold system. I like the idea of independent shut-off valves for each line at a central location. The manifold helps equalize pressure throughout the system. The long runs without a lot of fittings along the way seems to keep the down-stream water pressure up better. There are lots of good reasons to do the manifolds.

Putting the copper manifolds together with the correct PEX fitting takes a bit of soldering, enough so that we've gotten pretty good at it. My Wife has become quite the effective solderer!

Scott.