Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

need router bit for shoe molding

Posts

need router bit for shoe molding

#1

need router bit for shoe molding

Bill Tindall

Shoe is not quarter round. Typical shoe is something like 3/4 tall x 1/2" deep. Does anyone make a router bit to make shoe molding?

Re: need router bit for shoe molding

#2

Re: need router bit for shoe molding

a. heath

Mr tindall,

I use my shaper with a thunbnail bit (for tabletops). Set the cutter so that it only uses a portion of the rounding radius and use a fence for the half-inch stock.

Re: need router bit for shoe molding

#3

Re: need router bit for shoe molding

Robin Corell in Atascadero CA

Try either a 3/4 or 1" roundover bit on your 3/4x 1/2 stock with out tacking a full cut. Some times it works best on over size stock that you rip the moulding off of after you route it.

Robin

Re: need router bit for shoe molding

#4

Re: need router bit for shoe molding

FredD

Eagle router bit #169-2015 is the profile most used for Shoe mold.

FredD

Re: need router bit for shoe molding

#5

Re: need router bit for shoe molding

Barry Irby

Bill, I have a thumbnail bit and it would work. Run it on the edge and the shoe would be "laying down". Rip it off and stand it up. It has a guide bearing, but that would not help because the stock would be too thin for it to touch the bearing. This is a fairly big bit, about two inches in diameter and expensive (to me) at about $60. You could run it in a router table and it cut pretty sweet.

Re: need router bit for shoe molding

#6

Re: need router bit for shoe molding

John McGaw

Google for "shoe molding router bit" (without the quotes) for the answer. Hint: they aren't cheap but if you are doing a lot of sticks and have suitable wood and the time I guess it would be worthwhile.

Re: need router bit for shoe molding

#7

agree, and....

Grant in Iowa

These guys are right on here. I made a bunch for my house and took the following steps to ensure a good safe production run:

I used wider stock and shaped both edges at a router table on several boards at one time. Then moved to the table saw to rip off the edges of each board to complete each strip.

I used extensive feather boards and board buddies on my table saw to make the parts accurately and safely.

Regards,

Grant in Iowa

Re: need router bit for shoe molding

#8

Lee Valley 16J5572- perfect

Bill Tindall

I need to check my router bit collection before asking these questions. The LV bit is a perfect match for shoe molding. I suspect it is designed that way since it reproduces a Stanley 55 pattern.