Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Dowel size vs: Hole size

Posts

Dowel size vs: Hole size

#1

Dowel size vs: Hole size

Bob S

I am having a problem with dowels purchased at Lowes. They SEEM to be a little smaller than expected. I can't be sure (can't remember, that is), if a 1" hole, should be drilled for a 1" dowel, or if a smaller hole or larger dowel needs to be used.

My forstner bits seem to cut a very good, 1" hole, and I seem to recall that a 1" dowel SHOULD fit in snuggly. Please help.

Bob

Re: Dowel size vs: Hole size

#2

Dale Lenz

You are correct, Bob.

Dale Lenz

1" =1", back when I used dowells I used to drill the hole size I needed in a block of wood and take it with me while shopping for a dowell.

Re: Dowel size vs: Hole size

#3

Re: You are correct, Bob.

Jesse Cloud

I don't know how they do it, but I even find that Home Depot dowels aren't consistent in the same piece. That 1 inch dowel might be 1.1 on one end and 0.95 on the other.

Anyone out there make their own dowels?

Re: Dowel size vs: Hole size

#4

Dale Lenz

Spent a whole weekend once

Dale Lenz

making dowells of different flavors. Learn how by reading one of Patrick Speilman's books, using a router, elect. drill and fabicated jig. Learned quickly why dowells are not made out of ERC and some others, they break during the process! Calculated I made 150 dollars of dowells, 1991 prices, during that weekend, :D

Re: Dowel size vs: Hole size

#5

Re: You are correct, Bob.

FredD

Jesse, yes I make them using Lee Valley dowel cutters in 1/4", 3/8th's and 1/2".

The beauty of these cutters is that they allow for size adjustment up or down and naturally you can match the wood your using .

FredD

Re: Dowel size vs: Hole size

#6

Use a draw plate

Robin Corell in Atascadero CA

I always take my dial calipers with me when I go to buy dowel. I also have a draw plate I made when I was an apprentice and I use it to resize the dowel after I cut it into the lengths that I will use. Lie-Nelson sells a very high quality draw plate for resizing dowels and at a very reasonable price. In fact the one they make is nicer than the one I made myself and I have thoughtabout upgrading. If you would like to make your own you need to drill the hole undersize and then use a reamer size the hole and make it round, a twist bit will make a slightly three sided hole in metal plate.

Robin