Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

TS Problem

Posts

Re: TS Problem

#26

Seriously..........

Barry Turner

>A 1/32" variation in a three or four foot long board just ain't off all that much. Just remember that you have a Delta Contractor's Saw, not a Delta Unisaw with a Biesemeyer fence setup. By the way, I have one of those Delta Contractor's Saws. It's a great saw, but it does have it's limitations. My advice would be to learn to work with them.

Re: TS Problem

#27

Re: TS Problem

xeddog

>I have read just about all of the responses here, and I have something different you might try. I had the same problem with my Craftsman saw and I was thinking that it was just my cheapie saw. My hollow was not quite in the middle of the cut, but more near the end like about 6-8 inches from the trailing end. I went through it and aligned everything to where it was within .001" of being dead on and I still had the issue.

I resolved this simply adjusting the way I was pushing the board through. When I was pushing the board through, I was pushing on the piece between the blade and the fence, but also trying to support the cut-off piece. Especially near the end of the cut so that the off-cut wouldn't just break off. My guess is that I was adding just enough diagonal pressure to pull the board slightly out of alignment.

After I started letting the cut-off fend for itself, my cuts became straight and true.

xeddog

Re: TS Problem

#28

Re: TS Problem

Fred Davis

>That is a very insightful response.

You can easily cut a curve in a board by not using a constant repetitive grip on the board and a steady feed rate that accommodates the saw's power and blade's condition to produce straight cuts.

For tuning up the fence and all other parallel issues I use a snug fitting in the mitre slot 3/4 inch square steel bar 18 inches long provided by a Machinist friend.

In conjunction with that I use a ten inch steel saw disk blank provided by Nordic Tool in Turlock , Ca instead of trying to measure from a tooth with a dial caliper.

This way of setting tolerances seems to be fool proof and very easy and quick to use.

FredD