Re: Router Tables
George@Colonel's Workshop-Havertown PA
>Good Evening John,
My router table and cabinet is the second one I've built, and now incorporates a Jessem Mast-R-Lift and a big P+C 7518 router. The table top is 1 1/2" thick hard maple table stock and is 38 1/2" wide and 23 1/2" deep. I made it from 3/4" Birch ply faced with cherry. Drawers are cherry, and accommodate 1/2" bits on the left, and 1/4" bits on the right along with a utility drawer for set up bars and blocks, reserve bearings, and other gee whiz widgets. The shelf holds three P+C 690 routers with standard, D-Handle, and Plunge bases, and other accessories. Its a successful design based on AWW/Ellis' efforts of a few years ago. I used a commercial fence from MLCS, extruded aluminum, and am well pleased. I like the table size. The table/cabinet has developed into a very good tool for a very reasonable cost. You might think about making one of your own.
George
