Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Executing 35 degree lap joint

Posts

Re: Executing 35 degree lap joint

#26

Frank in Colorado Springs

Re: Executing 35 degree lap joint

Frank in Colorado Springs

>Good morn1ing, Dan. You might want to reconsider one of those old dinosaurs. It's just possible you'll find a real jewel.;-)

Not sure why a 38" piece of stock would present a challenge to a RAS. My table is 40" and many folks have extensions left & right of 8' and more.

To make the mitered half-lap I'd layout the joint, install a dado, set the arm to 35�, set depth of cut, place the workpiece against the fence, make the cut, repeat, assemble two pieces. No jigs, no hassle.

I think most of the prejudice regarding RAS is due to cheaply constructed saws that either can't be properly tuned or won't hold adjustments once tuned. Find an older Dewalt, pre 1960s with some exceptions, tune it up following Wally Kunkel's or Jon Eakes instructions and you'll be amazed as what you've been missing.

Take a look at the 10 board molding used for the frame in the attached pic. Wally taught a RAS class for years and he taught his students how to make this molding on a Dewalt RAS.


img

Re: Executing 35 degree lap joint

#27

Re: Executing 35 degree lap joint

Dan Mitchell

>Frank - I didn't realize the head/arm would pivot on an RAS as it does on a CSMS. I thought the travel had to either be 90 deg to the table, or parallel to it. You learn something new every day!

Re: Executing 35 degree lap joint

#28

Re: SCMS?

Dan Mitchell

>I didn't think my SCMS would swing that for - but it will. Don't even need any wedges. This seems like the best approach for me, thanks, Jason.

Re: Executing 35 degree lap joint

#29

Frank in Colorado Springs

Re: Executing 35 degree lap joint

Frank in Colorado Springs

>Isn't that the point of life....learn something new everyday ;-) As I, ahem, mature, I think I relearn something I knew everyday.