Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Small parts, bolts, pins, etc.

Posts

Small parts, bolts, pins, etc.

#1

Small parts, bolts, pins, etc.

Gary Smyth

>I'm looking for sources for very small stainless screws, eye bolts, clevis pins, shoulder screws, castle nuts. I've tried Fastenal, Small Parts, Shop Tools, B/G, West Marine, and Reis catalogs with no luck. I need miniature parts that will be used in a one off design. Buying a minimum 1000 is out of the question. I cannot find parts smaller than 1/4" in most offerings. Anyone have additional sources? I�m thinking 3/16� screw is maximum 1/8" would be better. Anyone have any aircraft or metal box manufacturers that offer smaller yet strong sizes.

Re: Small parts, bolts, pins, etc.

#2

" Micro Mark " . . .

steve mackay

>One of my favs for miniature parts and tools. Not sure about stainless though.

Re: Small parts, bolts, pins, etc.

#3

Re: Small parts, bolts, pins, etc.

john lucas

>I buy a lot of things from them but haven't checked on the small screws lately.

Re: Small parts, bolts, pins, etc.

#4

Re: Small parts, bolts, pins, etc.

Larry in NW Ohio

>Try www.McMasterCarr.com Larry

Re: Small parts, bolts, pins, etc.

#5

Sources for one-off miniature threaded hardware *LINK*

David Barnett - SW FL Gulf Coast

>Although you didn't really give specifics, when you need quantity '1' of miniature threaded products, your best bet is from horological suppliers. My two favorites are:

Frei & Borel

http://www.ofrei.com/

Jules Borel

http://julesborel.com/

Also, perhaps:

http://www.clockworks.com/

You should also check local camera repair shops and their suppliers. Independent horologists often have amazing loose parts boxes that might have something you could use.


The Horology Source

Re: Small parts, bolts, pins, etc.

#6

Also, the DIY solution *LINK*

David Barnett - SW FL Gulf Coast

>Search eBay for "screw-plate". You'll find sets of Indian and Pakistani taps & plates for about fifteen dollars up. Jules & Borel 'real' sets start just under three hundred.

If you only need a couple thread sizes, you can buy Bergeon taps & dies singly. The taps from J&B are under fifteen dollars, the dies triple that.


The boxed edition

Re: Small parts, bolts, pins, etc.

#7

Thank you all. I'm looking at your sources.

Gary Smyth

>