Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

remote for dc

Posts

remote for dc

#1

remote for dc

David Dircksen

>What would be a good remote for a 1 1/2 hp steel city dust collector

Re: remote for dc

#2

Re: remote for dc *LINK*

Andy Lincoln,in Dearborn MI

>David,

I have this one on my Steel City DC and it works just fine.

http://www.woodcraft.com/Product/2005117/8394/110V-Remote.aspx

Andy


http://www.woodcraft.com/Product/2005117/8394/110V-Remote.aspx

Re: remote for dc

#3

Re: remote for dc

Fred Davis

>David,

When I bought a Onieda Cylcone the remotes that came with it worked very good, for about two years and then I would have to get a new reciever.

This remote was by a outside vendor who was in Virginia, Florida and the last time I tracked them down they were another company and in California.

At that time they had four recievers on hand and I bought all of them.

The three remotes I have scattered around and one im my shop apron , never seem to go bad , just a battery change every couple of years.

So I guess if I was you , check with Onieda and see what they have now or if you wish , I can send you the last contact for the ones I have.

FredD

Re: remote for dc

#5

Re: remote for dc *LINK*

Dan Mitchell

>I've always favored one like the unit in the link. Woodcraft sells them for $45 (saw it in the current flyer, for some reason though it's not on their web site). Automatically turns on the DC when you power up a tool. Unfortunately (for my shop, anyway) as with most all of these, it's 120V only. If 120 works for you, check out the brochure you can DL on the page below.


http://www.ivacswitch.com/index.php

Re: remote for dc

#6

Re: remote for dc

Paul Cates - Henderson, KY

>I purchased a very similar setup about 8 yrs. ago:

http://www.smarthome.com/4003/X10-16-Device-Base-Unit-with-Keychain-Remote-for-2-Devices-RC6500/p.aspx

http://www.smarthome.com/2021/X10-Heavy-Duty-220V-Appliance-Module-HD245-or-PAM04/p.aspx

Re: remote for dc

#7

Re: remote for dc

Tony - Memphis

>I've been using the X10 stuff in my shop for around ten years too. Works very well. You can find real good deals on Ebay. I have bought several remotes and modules from an Ebay dealer and have had goodluck with them.

Tony

Re: remote for dc

#8

Whatever you do....

Dave Bair, Eaton Rapids, MI

>make sure you can replace the clicker separately from the control switch. In my experience, the clicker has a much shorter life-cycle than the control and it's much cheaper to replace it than the whole shebang.

Re: remote for dc

#9

Good point....

Tony - Memphis

>And they are extremely short lived after being swallowed by the evil dust collector! One thing I like about the X10 stuff is that I was able to replace my remote for 3for$9.99 on Ebay. All brand new in the box and work great.

Tony

Re: remote for dc

#10

Re: remote for dc

Larry in NW Ohio

>Dave did you get your motor back,Larry