Planer knives
Randy
>Putting new knives in a 36" Baxter Whitney planer and failed to note how far the old knives stood out above the head. Any advice?
Knowledge You Can Build On — Est. 1998
Planer knives
Randy
>Putting new knives in a 36" Baxter Whitney planer and failed to note how far the old knives stood out above the head. Any advice?
Re: Planer knives
Brian in Brighton
>I would start with them about .02 proud of the rollers. If the machine seems to run too easy, or too rough, adjust them.
Otherwise, look around for pdf's of the manuals of a similar machine and copy what it says.
Brian in Brighton
Re: Planer knives
Roy Girolami------WebKitFormBoundary9yANUT8mn8C+Zo
>Randy, my 12" Boice-Crane planer runs with about 1/8" projection of the knives. You'll want to get the widest knife that will fit so you can sharpen it a few times before it is too narrow fot the gibs to hold it in place.
Roy Girolami
Apex, NC
Re: Planer knives
Fred Davis
>Roy,
sometimes when someone tells me I live to much in the past , I tell they can't relate to my past unless they got to run machinery made by Boice-Crane, Oliver, Dewalt, Walker-Turner , Davis and Wells, Yates-American and so on. ;-))
I had a eight inch Boice-Crane jointer for years , I still have and use often ,their oscillating spindle sander, which runs nine inch sleeves.
FredD
Re: Planer knives
Robin Corell in Atascadero CA
>I just installed new knives on my Parks last week. The manual says that the knives should protrude no more than .100". The thing I was wondering is if HSS was standard in the early 40's and if there would be any difference in how you would set HSS vs high carbon knives.
Robin