Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

dust collection design

Posts

dust collection design

#1

dust collection design

LGraubner

>After working with a shop vac, 650 Jet and 1100 Jet, I just ordered the 3 HP JDS cyclone for my 20x30 shop. My current plan is to locate it in a corner of the shop where I can run about 15 feet of 6" main pipe and then install blast gates to connect to my 4" tools. This avoids the vertical runs to the ceiling.

Has anyone used the Jet metal piping and connectors and metal blast gates?

Re: dust collection design

#2

Re: dust collection design

Larry in NW Ohio

>I have a 3HP Onieda and I used S&D PVC for my piping, and I`m more than satisfied. It`s easy to work with and when you want to redo it, it`s very easy to do that, and the best thing you don`t have to worry cutting youself. If you want some help just email or post any questions you may have. Larry

Re: dust collection design

#3

Re: dust collection design

mdclor

>+1 on using S&D PVC. Check the price however, because I think PVC really increased when oil went sky high. I don't know if it has since dropped back any since then.

Also, one of the books I read suggested putting the dust collector closer to the center of the shop if possible to reduce the lengths of the various runs.

HTH,

Merle

Re: dust collection design

#4

Re: dust collection design

LGraubner

>Thanks for the tips. My current plan is to have it in line with my major chip producing tools with 1 14' main run of 6" line with 4" branches, each with a blast gate.

Re: dust collection design

#5

Re: dust collection design

Fred Davis

>LG,

when you say "major chip producing tools " if you mean a stationery planer or jointer , 4" is undersized for optimum chip removal.

FredD

Re: dust collection design

#6

Re: dust collection design

Chuck in ND

>If you can afford the metal ducting thats the route I would go. I don't even use any plastic flex anymore, I use metal flex.

Re: dust collection design

#7

Re: dust collection design

mdclor

>I have my 6" PVC lines run as close to the machine as possible, then connect to the machine with 4" flexible plastic, usually less than 4'. I know this isn't ideal, but it is cost effective. It also gives me the ability to move the machines slightly if necessary.

Re: dust collection design

#8

Re: dust collection design

Fred Davis

>there you go , ;-))

FredD