Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

OT - Hose valves and freezing

Posts

OT - Hose valves and freezing

#1

OT - Hose valves and freezing

Jay St. Peter - Southern, MD

>For the third time in 6 years I've cracked the hose valve on one side of my house. It is in the closet I keep my cyclone, which is insulated for sound so it stays colder in the winter. But, the real issue is that it is the closest hose to the driveway. So I take advantage of nicer winter days to get the crud off the cars and forget to turn it back off.

I use the longer hose valves that crack and don't leak until you turn them on. They don't make a big mess, but it's still a pain. Before I go solder another on, is there a better solution? If not, maybe some ideas to make it easier to replace every couple years. I have to get into a pretty tight area to do the soldering with plenty of insulation around.

TIA,

Jay

Re: OT - Hose valves and freezing

#2

Re: OT - Hose valves and freezing

Barry Irby

>You mention using one of the "longer" ones. Are you talking about the "freeze proof" kind that have a long tube that leads to the hose bib and the actual valve is at the rear? If so, those are actually more prone to freeze if you leave the hose attached. That tube is thin walled and somewhat delicate. Have you thought about leaving a light on in the closet. One of the old fashioned bulbs, not a CFL that is more efficient, but does not put off the heat. If you are concerned about the energy usage, you could put it on a thermostat that turned the heat/bulb on when the temp falls too low. You could use a heat tape. Or if conditions are not too severe, you could wrap it very thoroughly with insulation and hope for the best.

Re: OT - Hose valves and freezing

#3

Re: Hose valves and freezing - There's your sign.

Ray Carson, New Jersey

>Make a HUGE sign, make a few of them. It should read:

JAY,

DID YOU TURN OFF

THE WATER ???

Paint the letters red, hang one on the outside, the inside and right next to the hose bib. (valve) Sooner or later you'll find that you start doing it out of habit. Then you can take the signs down.

Whenever I'm doing electrical work and especially when I'm in the main panel. I post signs at the top of the steps, near the panel box anywhere so I will not forget whether or not to check and see if the main breaker is off or on.

My panel box signs say:

HOW WAS THAT LAST JOLT??

RAY, TURN OFF THE BREAKER !!


My wife just shakes her head......

My 2 cents worth,

Ray

Re: OT - Hose valves and freezing

#4

Re: OT - Hose valves and freezing

steve mackay

>Made me think of a REALLY good one. I was watching the nieghbor trying to remove an outside spigot with the claw on a hammer ( yes, the claw ). I couldn't take it anymore so walked over. Long story short I sent him to the store to get another spigot. They sent him back with "The Long One". Here in El Paso ! Since they charged him $14 for it I sent him back to exchange it for a "G.D. SPIGOT". My man (who is only doing what hes told !) comes back with both, "The Long One" and a nice brass one. They wouldn't exchange "The Long One" because they had no choice but to sell it to him because of "code" since he told them it was for outside application. The guy is too nice. That "Long One" is still on a shelf because he doesn't want to cause trouble. But, on the flip side, he DID learn to sweat fit that day.

Re: OT - Hose valves and freezing

#5

Re: OT - Hose valves and freezing

GalenV in Iowa

>A Woodford freeze proof sill cock will only work if you do NOT leave the hose connected. The sill cock must be sloped up inside so any water from the seat drains out the cock. You do not want to insulate the tube as you need the room air to heat the body. Since you use the hose during the winter just remember to remove it. If you need to provide more heat you can get a short section of heat tape and wrap the valve body that extends inside the house.

Here in Iowa if the wind and temp is right it can still conduct enough cold to freeze back at the seat. They do make foam insulated covers that toggle over the valve outside and try to trap some heat transmitted out the wall. Not real efective but them you cannot leave a hose on by mistake.

Galen

Re: OT - Hose valves and freezing

#6

Once You've Installed The New One

Dave's Not Here

>You could wrap it in heat tape. Then all you'll have to remember is to plug it in in the fall and unplug it in the spring.

Re: OT - Hose valves and freezing

#7

Re: OT - Hose valves and freezing

Del Williams

>That's the key - if you leave the hose connected there is a water column that is continuous to the seat. The hose will expand as the water freezes but the barrel of the sillcock will not. Water does a pretty good job of conducting temperature changes. If you're not disconnecting the hose from the bib, it's still gonna freeze and split the barrel.

Re: OT - Hose valves and freezing

#8

Heat Tapes

mdclor

>Others suggested heat tapes, but I would be very cautious with them, ask your local fire department about them. I agree with the post about using a light bulb as a heat source. It should be sufficient in your area considering the well insulated space.

Merle

Re: OT - Hose valves and freezing

#9

Re: Heat Tapes

Barry Irby

>I was one suggesting the use of a light bulb as a heat source. If you do, be careful, they can start fires. Also, use two, smaller ones. That way if one goes out, the other will still protect you and give you a chance to catch it before something freezes.

Re: OT - Hose valves and freezing

#10

Re: Heat Tapes

Lee Schierer - McKean, PA

>Check out the self limiting heat tapes that use a semiconductor material for regulating heat instead of a thermostat. They are considerably safer than the thermostat controlled tapes and use far less energy. They are also considered safe for plastic pipes.

Lee


img

Re: OT - Hose valves and freezing

#11

Re: OT - Thanks guys

Jay St. Peter - Southern, MD

>I'll look into heat tape. I have been using a light bulb, but anything that requires me to remember to do something isn't going to work. Also, the closet is right below the playroom. Every time I leave the light on, the kids manage to jump around enough to knock it out.

I definitely need something that is thermostat controlled. Looks like the decision is between light bulbs and heat tape. Light bulbs might work out since my basement sump is in the same closet. I'll just have to locate some so they are isolated from the ceiling.

Re: OT - Hose valves and freezing

#12

I'd move it

Tim Greif - West of Chicago

>The problem is the closet, not the sillcock. It can't take much to move the sillcock to a location adjacent to the closet where it will get the benefit of warmer ambient air, and still be accessible to the driveway. That solves the issue, as long as the hose is disconnected.

Re: OT - Hose valves and freezing

#13

Re: OT - Hose valves and freezing

John K Jordan

>Any room in your yard for an outside hydrant? I have several - an old one at the barn and I ran a new one out to the chicken house a few years ago. The valve is buried deep in the warm ground and the pipe to the spigot drains every time you turn it off to prevent freeze damage. (Somewhat similar to the freeze-proof wall faucets in this respect.)

Unlike the freeze-proof external faucets which will certainly burst if the hose remains connected (which prevents draining), the outside hydrant may still freeze up if I leave a hose connected but I've never had one break. However, I'm sure it would self-destruct if pressure was left on the hose.

JKJ

Re: OT - Hose valves and freezing

#14

Re: Heat Tape Danger!

Tom MacGregor

>Use ONLY the self-limiting type. Around here we call the cheap flat heat tape "trailer tinder". The cost of the good stuff is more than worth the performance and added safety.